1. Mark four holes on the door for the door closer and two
holes on the frame door for the door closer and two holes
on the frame for the arm shoe.
2. Drill 4mmØ pilot holes in the door and frame for the fixings
supplied.
3. Fix the forearm/arm shoe assembly to the door frame using
the fixings supplied.
4. Attach the closer to the door using the fixings supplied.
Note: The speed adjusting valve must be positioned
towards the hinged edge of the door.
5. Install the main arm onto the top pinion shaft, perpendicular
to the door as illustrated below. Tightly secure it in place
using the screw/washer assembly supplied.
6. Adjust the length of the forearm so that it is perpendicular
to the door frame when assembled to preloaded main arm
(see ‘top view’illustration below). Secure the forearm to the
main arm using the screw/washer assembly provided.
7. Snap the pinion cap over the pinion shaft at the bottom of
the closer unit.
8. Adjust the closing speed of the door
