2.1 Intended use
The EM Break-out System is an automatic sliding door operator developed to facilitate entrances
to buildings and within buildings through sliding doors.
The EM Break-out System is designed to be surface-mounted to the wall or a beam. It is easy to install
for both new construction and retrofit application, and it can be adapted to a wide range of door
requirements. It is to be installed indoors where it is suitable for almost all types of external and
internal sliding doors.
A EM Break-out System operator can be combined with the full range of Entrematic Group safety
units, such as presence and motion sensors.
The door is designed to offer continuous use, a high degree of safety and maximum lifetime. The
system is self-adjusting to the effects caused by normal variations in the weather conditions and
to minor friction changes caused by e.g. dust and dirt.
In emergency situations the doorset is opened and remains open automatically. It may also be
equipped with break-out function, in which case the door leaf is pushed manually open in the escape
direction.
This manual contains the necessary details and instructions for the installation, maintenance and
service of the Sliding Door Operator EM Break-out System.
Save these instructions for future reference.
2.2 Safety precautions
Be sure to complete a risk assessment and site acceptance test before taking the door into operation.
To avoid bodily injury, material damage and malfunction of the product, the instructions contained
in this manual must be strictly observed during installation, adjustment, repairs and service etc.
Training is needed to carry out these tasks safely. Only Entrematic Group-trained technicians should
be allowed to carry out these operations.
2.3 Electronic equipment reception interference
The equipment complies with the European EMC directive (US market FCC Part 15), provided in-
stalled according to Installation and Service manual.
The equipment may generate and use radio frequency energy and if not installed and used properly,
it may cause interference to radio, television reception or other radio frequency type systems.
If other equipment does not fully comply with immunity requirements interference may occur.
There is no guarantee that interference will not occur in a particular installation. If this equipment
does cause interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
•Re-orient the receiving antenna.
•Relocate the receiver with respect to the equipment.
•Move the receiver away from the equipment.
•Plug the receiver into a different outlet so that equipment and receiver are on different branch
circuits.
•Check that protective earth (PE) is connected.
If necessary, the user should consult the dealer or an experienced electronics technician for addi-
tional suggestions.
1003658-EMEI-2.0Issue 2014-03-206
2 Important information
