User Manual
4;&9%#A%;&4;&
Below table contains confi uration settin s. This settin s can be sent via SMS or can be sent via terminal.
1. We will use below sequence:
se
t
_<COMMAND>@<SER
I
AL>$<PASSWORD
>
#
<COMMAND
STR
IN
G>#
2. For Set Commands – after settin device should response – “success” followed by command.
Ex: “set_server success” OR “set_server failure”
#
This command confi ures the connection settin s which consist of service provider
APN, Server IP address/DNS, & Port number.
Usage:
set_
server@<ser
i
al
>%<
pa
ssword>#<
a
pn>,<apnuser>
,
<apnpassword>,<serverip1>,<serverport1>,<serverip2>,<serverport2>,<serverip3>,<serv
erport3>#
xample:
set_server@12345%123456#airtel prs.com,,,13.250.246.255,9022,
13.250.246.255,9022,13.250.246.255,9022#
2 SET_INTERVAL
This command is used to confi ure the transmission interval. This consistin of IGN On
interval in seconds, IGN Off interval in seconds.
Usage:
set_
interval@<serial>%<pa
ssword>#<o
n interval>,<off inte
rval>#
xample:
set_interval@12345%123456#10,60#
Valid Values:
10, 20, 30,40,50,60 – for ON Interval in Seconds
10,20,30,40 to 1800 – for OFF Interval in Seconds, Less than 30 minute (1800 Sec)
This command is used to set the vehicle identifier number
Usage:
set_
vin@<serial>%<pa
ssword>#<vehic
l
e number>#
xample:
set_vin@12345%123456#GJ01RH4270#
Note: Max 20 character limit.
This command is used to set the client ID
