INTRODUCTION
This modem is the LRE(Long Reach Ethernet) bridge that efficiently extends 10/100 Ethernet circuits
to 2 wire-Networking LAN for Internet or Intranet access. Over 915 meters(3,000feet) at 50Mbps using
existing phone wire. This modem will allow Ethernet connectivity in existing facilities without pulling
extra cable. This is perfect solution to Ethernet on the factory floor where systems have been upgraded
from slower serial communication to Ethernet networking. Installation is easy with a single switch setting.
One end is set for local and the other remote. This modem is used in phone wire to extend Ethernet
connectivity over existing phone grade phone wire.
Key Features
High-Speed 100/95Mbps communications link over existing phone line cable,Asymmetrical on LRE
50Mbps@ 915 meters(3,000feet), reach down to 20Mbps @ about 1.7Km(5,600feet)
Operates transparent to high layer protocols such as TCP/IP
Auto-MDIX and Auto-sensing 10Base-T or 100Base-TX and Full or Half-Duplex on the Ethernet
port
Plug and Play design for simple installation, single DIP switch for configuration.
Status LEDs for simple monitoring of the device and connection status
Point to Multi-Point Application（Extend Application）
HARDWARE INSTALLATION
