EMU MAX BAR 1356 Guida rapida
ASSEMBLY INSTRUCTION
MAX BAR BASE #1356, #1357
emuamericas, llc 800-726-0368
emuamericas, llc 800-726-0368
9. Add (E)levers to base and make sure the
table bases and spider are aligned the same
CARE & MAINTENANCE
GENERAL MAINTENANCE
As with any equipment, proper and periodic maintenance is necessary to ensure longevity of the
product and customer satisfaction. To ensure you get the most out of your investment, please follow our
recommended maintenance and care instructions.
We recommend that the products be examined every 30 days. Items requiring adjustments, showing
any sign of structural failure, that have missing hardware or that show any cracks at the welds should be
taken out of service immediately until repaired.
Loose screws should be tightened as required and missing or worn out foot caps must be replaced.
To obtain replacement parts, please contact your local representation or local dealer.
Furniture should be handled with care. When chairs are stacked, the stack should not be dragged.
Stackable chairs should not be dropped or slammed down when being un-stacked. People should not
rock backwards or stand on any emuamericas’ item.
For storage, all furniture should be stored neatly, stacked to suggested height, and packed in a clean
and dry area. Tables should not be ipped and stacked; any standing water needs to be removed to
avoid damage to nish.
NOTE: Warranty may be voided if proper maintenance or care is not followed.
Full maintenance and care instructions for each product can be found on our website at
www.emuamericas.com
PARTS/HARDWARE
We make available all parts, hardware and touch-up paint for the current product line at minimal cost.
emuamericas, llc 800-726-0368
(A) Spider x1 (B) Base x1
(C) Threaded Rod x2 (E) Levers x4 (F) Nut x4
(D) Column x2 (G) Washer x3 (H) Lock Washer x3
emuamericas, llc 800-726-0368
2. Place (F) nut into (A) spider 3 . Flip spider over and add (C) threaded rod adding
(G) washer, (H) lock washer and (F) nut. Tighten
5. With spider on the ground, place (D) columns
on to (A) spider making sure tabs line up
6. Then place the (B) base on (C) threaded rod and
(D) column and making sure tab lines up with base
7. With (B) base on, place (G)washer, (H) lock washer
and (F) nut
C
8. Tighten.
Suggestion: use thread lock that can be purchased
at any local hardware store
4
1. Take both threaded rods and attach them together,
be sure to use (F) nut, (H) lock washer and (G) washer
4. Take both (D) columns and join them together
with (I) coupler as shown
(I) Coupler x1
Questo manuale è adatto per i seguenti modelli
1
Altri manuali EMU Rack e supporto
