EMX Industries, Inc. PC-3 Manuale utente
O P E R A T I N G I N S T R U C T I O N S
Operating Instructions
4564 Johnston Parkway, Cleveland, Ohio 44128
P. 800 426 9912 F. 216 518 9884
www.emxinc.com
PC-3™
THRU BEAM PHOTOEYE
U L 3 2 5 N O N - C O M PL I A N T
PC-3™ Operating Instructions Rev 1.4 1
Document no.
Contents
Cautions and Warnings
2
Product Overview
2
Specifications
2
Connections
3
Troubleshooting
4
Ordering Information
4
PC-3™ Operating Instructions Rev 1.4 2
Document no.
Cautions and Warnings
WARNING … Not to be used for Personnel Protection
Never use product as sensing devices for personnel protection. Doing so could cause serious
injury or death.
These sensors do NOT include the self-checking redundant circuitry necessary to allow their use in
personnel safety applications. A sensor failure or malfunction can cause either an energized or de-
energized sensor output condition. UL 325 Non-compliant
Product Overview
The PC-3 photoeye system does not have a focusing lens and the generous 24osensing angle makes it
one of the easiest to align. Do not use outdoors or where there is chance of getting wet.
Specifications
Specifications
Power Supply
12-24 VDC 24 VAC
Power Supply Tolerance
+/- 20%
Current Draw
Tx: 37mA Rx:23mA Standby, 17mA Detect
Housing Material
PVC Black
Relay Type
Form C DPST contact rating 1A@24VDC/120VAC
Temperature Range
-40Fº -170Fº
Connections
Tx: 18in 2 Conductor RX: 18 in 5 Conductor
Detect Indicator
Red LED
Power Protection
Thermal Fuse
Environmental
IP50 Not water tight
Range
30 Feet
Response Time
10mS (max.)
Size
4in. x 2in. x 1.5 in.
Detection Angle
24º
PC-3™ Operating Instructions Rev 1.4 3
Document no.
PC-3 Transmitter connections (figure 1)
1. Connect power Red (+) positive
2. Connect power Black (-) negative
Not polarity sensitive
PC-3 Receiver connections (figure 2)
1. Connect power to Red (+) positive
2. Connect power to Black (-) negative
3. Connect White internal relay common to
operator input Common or Gnd as specified
by operator manual
4. Connect Green internal relay normally open to
operator input open, safety reverse or other
as specified by operator manual
5. The Brown internal relay normally closed is
not normally used and may be just cut off or
left alone
6. The detect Led will glow red when an
obstruction occurs.
Connections
Transmitter
Receiver
Red Wire
Power Positive (+)
Power Positive (+)
Black Wire
Power Negative(-)
Power Negative(-)
White Wire
Internal Relay Common Output
Brown Wire
Internal Relay Normally Closed Output
Green Wire
Internal Relay Normally Open Output
Power is not polarity sensitive
Detect LED
Figure 1 Figure 2
PC-3™ Operating Instructions Rev 1.4 4
Document no.
Troubleshooting
Symptom
Possible cause
Solution
Holds gate open
No power on Tx or Rx
Check power source, Check detect LED
Does not activate gate
Bad connection or
broken wires
Relay Contacts
burned or stuck
Not connected to
correct input
terminals
Sunlight “blinding”
the receiver eye
Check wires and connections
Replace receiver
Check operator manual for terminals
Change position of receiver to shield
the sensor from the direct sunlight
Chattering
Interference or stray
bounced signal
See if any reflective surfaces could be
sending signal into the receiver sensor
Ordering Information
PC-3 PC-3 Transmitter and Receiver
Accessories
IRB-BR Set of 2 L Mounting Brackets
PC-3™ Operating Instructions Rev 1.4 5
Document no.
Warranty
EMX Industries Incorporated warrants all products to be free of defects in
materials and workmanship for a period of two years under normal use and
service from the date of sale to our customer. This warranty does not cover
normal wear and tear, abuse, misuse, overloading, altered products, damage
caused by incorrect connections, lightning damage, or use other than intended
design.
There is no warranty of merchantability. There are no warranties expressed or
implied or any affirmation of fact or representation except as set forth herein.
EMX Industries Inc. sole responsibility and liability, and the purchaser’s
exclusive remedy shall be limited to the repair or replacement at EMX
Industries option of a part or parts found not conforming to the warranty. In
no event shall EMX Industries Inc. be liable for damages, including but not
limited to damages resulting from non-conformity, defect in material or
workmanship.
Effective date: January 1st, 2002
PC-3™ Operating Instructions Rev 1.4 6
Document no.
4564 Johnston Parkway
Cleveland, Ohio 44128
United States of America
www.emxinc.com
Technical Support: (216) 834-0761
Sales: (216) 518-9888
Fax: (216) 518-9884
Revision 1.4
7.13.2018
Indice
Altri manuali EMX Industries, Inc. Sistema di sicurezza
Manuali Sistema di sicurezza popolari di altre marche
EDM
EDM Solution 6+6 Wireless-AE Manuale utente
Highway Safety Group
Highway Safety Group EA401 Manuale utente
Siren
Siren LED GSM Manuale utente
Detection Systems
Detection Systems 7090i Istruzioni per il montaggio
Se-Kure Controls
Se-Kure Controls MicroMini SK-4841 Manuale utente
Siemens
Siemens FDM273 Manuale utente