Base
Holes
Thumbscrews
Cover
Diffuser
Middle tier
Spike
Post
Pins
Pins
Wire
Connector box
11W Incandescent
T5 wedge bulb
Bulb socket
1. Assembly of the Light Fixture
2. Run the Landscape Wire (Not Included)
3. Choosing Lighting Fixture Location
The landscape wire should run from the transformer to each light without being cut. Do not run the landscape
wire within 10 feet (3m) of a pool, spa or fountain. If the landscape wire is too long, cut it with a cable cutter.
The landscape wire should be protected by routing it close to proximity of the light xture or next to a
building, deck or fence. Use cable suitable for low voltage landscape lighting.
See chart below for recommended cable gauges.
*Suitable cable should be sized in accordance to the table, should be Type SPT-2W. If you cannot nd this cable at your local hardware or home improvement store then
please call customer service at 1-8
8
8-86
7-6
09
5 or e-mail at
[email protected] to order the cable needed.
For uniform brightness and longer bulb life, attach rst xture at least 10 feet from transformer.
Once you have decided where you will install your xtures, verify the type of soil.
•If the soil is of a loose, sandy or organic type, grasp the xture post, close to the spike, with both hands and rmly push into the ground.
• If the soil is heavy or stony, dig a small hole, insert the xture spike, replace the soil and tap down.
Never push the xture into the ground by the xture head.
Combined wattage of all fixtures on line (in
Watts) Wire Gage (0-75')Wire Gage (75'-150')Wire Gage (150'-250')
0-60 16 16 12
60-120 16 12 12
120-180 12 12 12
180-240 12 12 Not recommended
240-300 12 Not recommended Not recommended
Calibre del cable
(75'-150')
Calibre del cable
(0-75')
Calibre del cable
(150'-250')
0-60 16 16 12
60-120 16 12 12
120-180 12 12 12
180-240 12 12
240-300 12
Voltaje combinado de todas las lámparas
(en vatios)
No recomendado No recomendado
No recomendado
* llustration of xture is for example only.
1.1 Carefully remove the xture from its protective
packaging.
1.2 Attach spike, post and base together by turning them
clockwise.
1.3 Remove the three (3) thumbscrews, lift off cover, diffuser
and middle tier to give access to the bulb socket.
1.4 Insert the bulb into the bulb socket.
1.5 Assemble the cover, the diffuser and the middle tier as per
the picture by aligning the pins with the holes on
the base.
1.6 Attach the head assembly to the base by using the three (3)
provided thumbscrews.
4. Connect the xture wire to the landscape wire
4.1 Unscrew and
remove the lid of
the connector box.
4.2 Remove the rubber plug from
the channel marked 16G or 12G and
press the landscape wire into the
proper slot.
4.3 Replace the lid on the connector box and
close it tightly using the 3 screws making sure
the top and bottom of the box are tight to
each other. Turn on the power unit. If the light
xture does not turn on, repeat operations
4.2 and 4.3.
4.4 For the last xture only:
cut the landscape wire with a
cable cutter and wrap the end
with electrical tape.
To transformer
To light xture
Landscape
wire
Fixture wire
CAUTION
BE CAREFUL!
THE WIRE STABS
ARE VERY
SHARP!
