
1. Plug in to charge and connect
2. Copy les to PC
3. Open enDAQ Lab software
4. Set rates & triggers
5. Disconnect
6. Mount to surface
7. Press large button to start
8. Plug into PC to view data
SSERIES WSERIES
LED When Connected to Power Battery Check
● ● ● 100% charged Above 75%
● ● ● Charging Between 20% and 75%
● ● ● Unable to charge due to extreme temperature Below 20%
● ● ● Not operating properly or connected correctly Battery is dead
● ● ● Computer is accessing les
LED Blinking Mode*Status
● ● ● > ● ● ● No Lights O
● ● ● > ● ● ● Blinking - Red & Green, Green Waiting for a trigger
● ● ● > ● ● ● Rapid Blinking - Green Recording: Battery above 75%
● ● ● > ● ● ● Rapid Blinking - Red & Green Recording: Battery below 75%
● ● ● > ● ● ● Rapid Blinking - Red Recording: Battery below 20%
LED Blinking Mode*Status
● ● ● > ● ● ● Blinking Blue Searching for Wi-Fi network
● ● ● > ● ● ● Solid Blue, Blinking Green Connected to Wi-Fi, Uploading le
● ● ● Solid Green (1 second) Successful upload**
● ● ● - ● ● ● Solid Red (1 second) Unsuccessful upload**
* The rate of blinking (approx. once a second) is slower than during acquisition
** Sensor may re-enter recording sequence after successful or unsuccessful upload
W-Series sensors can be congured with
the wireless turned o to operate the
same as S-Series sensors. The following
is for using the wireless functionality of
these sensors.
The LED indicator denotes battery life, operating modes,
and potential errors.
If your sensor becomes unresponsive, please perform
a hard reset of the sensor by holding down the center
button until all three LEDs light up.
More details: support.endaq.com/leds
LED STATUS GUIDES When Connected to Power/Battery Status Check hold button until LED turns o During Operation All sensors Finished Recording & Uploading Wi-Fi enabled sensors only
* S Series: A Blue Light blinking during operation indicates IMU is not calibrated.
* W Series: A solid Blue Light while recording indicates that the GPS is on but has not yet secured a lock with the satellites.
* W Series: A rapid blinking Blue Light while recording indicates the GPS is on and has secured an accurate lock with the satellites.
We recommend copying the les from
your sensor to a local folder on your PC
--then use the local les.
Getting Started: S Series
1. Plug into PC. Open enDAQ Lab Software,
select "Congure a Recording Device"
2. Connect to your wireless network using
the Wi-Fi tab of sensor's cong. screen
3. Verify that the "Connected" box to the
right of your network is checked
4. Keep sensor connected to power
5. Create an account at cloud.endaq.com
6. On the “Link a Sensor” page, enter
the sensor's serial number
7. Wait for sensor's LEDs to alternate red,
then green, repeating
8. Hold down the button for 5 seconds
9. Your sensor is now connected to
the Cloud!
By default, the sensor does not upload
recordings, but this can be set in the
"General" tab of the device cong.
Getting Started: W Series
Please note:
Connecting: When sensor is connecting to Wi-Fi, all LEDs will blink on and o.
Pairing: When the sensor is pairing, the LEDs will alternate red then green, repeating.