- 5 -
4-2. System settings using mobile phone apps
(ETS-1000L) (Mobile phone apps)
1) Run / Set key for the ETS-1000L is set to Set position.
- If you set the position of the Set, the number display LED will be displayed with the Set.
2) Install the Endo Medical app to a mobile phone. The tagging the mobile phone to the RFID
reader of the ETS-1000L. This mobile phone apps is run. Once again, the RFID reader to tag
the mobile phone. This displays the device ID, address, and port number of the server set
in the ETS-1000L.
3) Modify the data of mobile phone apps and check the entries Register (∨) and tagging
the reader again.
- When stored properly, it displays the message "Write successful".
4-3. Install
Depending on the network configuration of the endoscopic management system and attach it
to the designated place of endoscopic checker, sterilizers, storage box.
Caution - The device ID registered in the endoscopic management server must match the registered
location and installation site.
4-4. How to use in the laboratory
1) Examination start :
a) Input of doctor and patient data : Data of doctors and patients, endoscopic management
system server, enter the data in conjunction with the hospital's systems and servers.
b) Scope tag input : Tagging the RFID tag attached to an endoscope.
c) Tester input tag : To tag the tester tag.
- When the Normal Front LED (S, D, P, T) both is turned ON, the server stores the input data
to the examination start.
2) Examination end :
a) Nurses enter tags : When the examination is started and once again input of the nurse tag,
the server then automatically stores the input data as examination end.
- When the normal examination is end, all Front LED will turn OFF.
