About this Manual
Read thisuser manual carefully before installing and operating yourEnersound Interpretation System. Use
theequipment only asdescribed to avoid accidental injury, damage or hearing impairment. Also, read safety
warnings carefully. Keep this manual for future reference. If you give this system to someone else,
remember to include this manual.
Safety Precautions
•Make all connections before plugging the unitinto an AC power outlet.
•Hot swapping isprohibited: Never connector disconnect any cables with the system turned on, especially
the25-pin cables. Always turn off the system before plugging or unplugging interpreterunits,
microphones or cables so as not to damage the system.
•Do not leavethe devices in places with high temperatures orhigh humidity.
•Donothandle the powercord with wet hands.
•Keep the devices away from fire and heat sources.
•Donotplace the equipment on an unstable stand. Use appropriate ororiginal packaging providedby the
manufacturer before transporting the system toavoid damaging or breaking it.
•Adequate ventilation is beneficial for better performance and storage of the equipment.
•Keep the system out of the reach of children.
•The CU-12 must be connected to ground via the power cable for safety reasons and to ensure the audio
performance of the system.
•Do not open the CU-12 and/orinterpreterconsoles. There are no user serviceable parts inside.
•Before using this product with a pacemaker or other medical device, consult your physician or the
manufacturer of your pacemaker or other medical device.
•Using thisproduct at a loud volume or over a prolonged period of time can lead to permanent hearing
damage.
•Reduce the volume to its lowest setting before use.
•When using XLR microphone inputs, connect only microphones that can accept 48Volt Phantompower;
otherwise, there may be riskof damage, injury, fire or explosion.
•When using a mobile phone near thisproduct, noise maybe produced, but this is nota malfunction.Keep
mobile phones as faraway as possible from the product.
•To clean, be sure to first switch off and unplug the CU-12 from the power outlet, then wipe with a dry
cloth. When extremely dirty, use a soft cloth dampened in neutral detergent. Never use benzene, thinner
or chemically-treated towels, which may damage the product’s finish.
•Only use Enersound approved cables to connect the system.Do notuse any accessory not recommended
by the manufacturer.
•A maximum of 11 sets of IC-12 can beconnected in one system. The cumulative cable length should not
exceed 70 meters. For specific requirements,please contact Enersound at 1 800-644-5090 or
support@enersound.com.
•Service must be performed by authorized technicians only.For service, please contact your local
distributor or Enersound at 1 800-644-5090 or support@enersound.com.
•Turn off the power supply and unplug the equipment from the power supply in case the equipment is not
in use for a long time.
Please register the product within 30 days of purchase. To Register Product:
1) Go to www.enersound.com/registration.html
2) Follow instructions to complete the online product registration form.
