Kamai Hybrid TV Receiver User’s Guide
3
Copyright
2011 Entone, Inc. All rights reserved.
IEEE 802.11b or802.11g operationof this product in the U.S.A. isfirmware-limited to channels
1 through 11.
This device is intended only for OEM integrators under the following conditions:
1) Thetransmitter module may not be co-located withany other transmitter or antenna,
2) For all products market in US, OEM has to limit the operation channels
in CH1 to CH11 for 2.4G band by supplied firmware programming tool.
OEM shall not supply any tool or info to the end-user regarding to
Regulatory Domain change.
As long as 2 conditions above are met, further transmitter test will not be
required. However, the OEM integrator is still responsible for testing their
end-product for any additional compliance requirements required with this
module installed (for example, digitaldevice emissions, PC peripheral
requirements, etc.).
IMPORTANT NOTE: In the event that theseconditions can not be met (for example certain
laptopconfigurations orco-location with another transmitter), then the FCC authorization is no
longer considered valid and the FCC ID can not be usedon thefinal product. In these
circumstances, the OEMintegratorwill be responsible for re-evaluating the end product
(including the transmitter) and obtaining a separate FCC authorization.
End Product Labeling
The final end product must belabeled in avisible area with the following: “Contains TX FCCID:
RRK-WMPN12A1”.
Manual Information To the End User
The OEM integrator has to be aware not to provide information to the end
user regarding how to install or remove this RF module in the user’s
manual of the end product which integrates this module.
The end user manual shall include all required regulatory
information/warning as show in this manual.
Entone products are designed and tested to meet IEC60065, the
standard for the Safety of Information TechnologyEquipment. This is the
international standard for these types of products to reduce the risk of
product damage and of personal injury. The standard protects against
the following hazards:
•Electric shock
•Hazardous voltage levels
•Fire — Overload, temperature, materialflammability
•Energy — Circuit with high energyor potential as burn hazards
•Heat — Accessible part of the product at high temperatures
•Radiation
•Noise
Canada Certification Notice The Industry Canada label identifies certified
equipment. This certification means that the equipment meets certain
telecommunications network protective operations and safety
requirements as prescribed in the appropriate Terminal Equipment
Technical Requirements document(s). The departmentdoes not
guarantee the equipment will operate to the user’s satisfaction. This
equipment meets the applicable Industry Canada Terminal Equipment
Technical Specification. This is confirmed bythe registration number. The
abbreviation, IC, before the registration number signifies that registration
was performed based on a Declaration of Conformityindicating that
Industry Canada technical specifications were met. It does not implythat
Industry Canada approved the equipment. The Ringer Equivalence
Number (REN) is 0.0. The Ringer EquivalenceNumber that is assigned
to each piece of terminal equipment provides an indication of the
