ETC Source four fresnel Manuale utente

Part Number: 7064M1200 Rev: B

Released: 2018-08

Source Four®Fresnel

User Manual

ETC

and Source Four

are registered trademarks of Electronic Theatre Controls, Inc. in the United

States and other countries.

All other trademarks, both marked and not marked, are the property of their respective owners.

ETC intends this document, whether printed or electronic, to be provided in its entirety.This

product is intended for professional use only. Read this entire document before using this product.

Table of Contents i

Table of Contents

Basic Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . 1

Lamp Information . . . . . . . . . . . . . . . . . . . . . . . . 2

HPL Lamp Table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2

Installing and Replacing the Lamp. . . . . . . . . . . . . . . . . . . . . .3

Adjusting the Field Angle . . . . . . . . . . . . . . . . . . 5

Using Accessories . . . . . . . . . . . . . . . . . . . . . . . . . 6

Adjusting the Yoke . . . . . . . . . . . . . . . . . . . . . . . 8

Adjusting the Yoke Balance Point . . . . . . . . . . . . . . . . . . . . . .8

Adjusting the Fixture Angle . . . . . . . . . . . . . . . . . . . . . . . . . . .8

Replacing the Lens. . . . . . . . . . . . . . . . . . . . . . . . 9

Removing the lens. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9

Installing the lens . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10

Cleaning the Glass Lens and Reflector . . . . . . . . . . . . . . . . . .10

ii Source Four Fresnel User Manual

Basic Assembly 1

Basic Assembly

Figure 1: Source Four Fresnel fixture components

WARNING: Please note the following safety warnings before use:

• Do not use this fixture with a damaged power lead. If the power lead

(cordset) is damaged, it must be replaced.

• Do not mount the fixture on or near combustible surfaces.

• Do not operate the fixture without a lens installed.

• Always hang the fixture with the accessory holder door in the locked

position.

Field angle adjustment knob

Yoke

Color frame holder

Fresnel lens

Safety screen

(CE markets only)

Lamp holder base

Accessory holder door

Lamp door

Lamp

2Source Four Fresnel User Manual

Lamp Information

HPL Lamp Table

CAUTION:

Do not use lamps other than the HPL in Source Four fixtures. Use of lamps

other than HPL will void UL/cUL safety compliance and your warranty.

Lamp Code Watts Volts Initial Lumens Color Temp. Average Rated Life

HPL 550/77* 550 77 16,170 3,250 K 300 hours

HPL 550/77X* 550 77 12,160 3,050 K 2000 hours

HPL 750/115 750 115 21,900 3,250 K 300 hours

HPL 750/115X 750 115 16,400 3,050 K 1500 hours

HPL 575/115 575 115 16,520 3,250 K 300 hours

HPL 575/115X 575 115 12,360 3,050 K 2000 hours

HPL 375/115 375 115 10,540 3,250 K 300 hours

HPL 375/115X 375 115 8,000 3,050 K 1000 hours

HPL 750/120 750 120 21,900 3,250 K 300 hours

HPL 750/120X 750 130 16,400 3,050 K 1500 hours

HPL 575/120 575 120 16,520 3,250 K 300 hours

HPL 575/120X 575 120 12,360 3,050 K 2000 hours

HPL 750/230 750 230 19,750 3,200 K 300 hours

HPL 750/230X 750 230 15,600 3,050 K 1500 hours

HPL 575/230 575 230 14,900 3,200 K 400 hours

HPL 575/230X 575 230 11,780 3,050 K 1500 hours

HPL 375/230X 375 230 7,250 3,000 K 1000 hours

HPL 750/240 750 240 19,750 3,200 K 300 hours

HPL 750/240X 750 240 15,600 3,050 K 1500 hours

HPL 575/240 575 240 14,900 3,050 K 400 hours

HPL 575/240X 575 240 11,780 3,050 K 1500 hours

HPL 375/240X 375 240 7,250 3,000 K 1000 hours

* To be used with ETC Dimmer Doubler™

Lamp Information 3

Installing and Replacing the Lamp

A lamp must be installed before you use the fixture.

Figure 2: Lamp door on bottom of the fixture

1: Disconnect power to the fixture before installing or replacing the lamp.

2: On the bottom of the fixture, turn the latch on the lamp door one quarter-turn and then open

the door.

3: Remove the lamp holder assembly by turning the knurled knob counterclockwise to release the

lamp socket assembly.

4: Twist the lamp socket assembly counterclockwise one quarter-turn and remove from the fixture.

Figure 3: Remove lamp with quarter-turn counterclockwise

Note:

Verify that the HPL lamp you intend to install is suitable for your facility’s voltage;

115V, 120V, 230V, and 240V HPL lamps are available. See HPL Lamp Table on

page 2. Operating HPL lamps above their rated voltage reduces lamp life and can

cause premature lamp failure.

WARNING: Unplug the fixture and allow it to cool down before changing the lamp.

CAUTION:

The socket assembly remains connected to the fixture by means of its

electrical leads. Do not pull the wired assembly or place undue stress on it.

Lamp door latch

Lamp door

Lamp holder

assembly

Turn to

remove

4Source Four Fresnel User Manual

5: If replacing a lamp, carefully remove the old lamp from the lamp socket assembly.

6: Holding the new HPL lamp by the base, remove it from its box.

7: Align the flat sides of the lamp base with the retention brackets on either side of the socket in

the lamp holder assembly as shown in

Figure 3

8: Push down on the lamp base until the lamp seats firmly. When properly installed, the top of the

lamp’s base will be even with the top edges of the retention brackets.

9: Reinstall the lamp holder assembly into its socket in the fixture so that the arrow points towards

the “unlock” icon on the socket.

10: Turn the lamp holder assembly clockwise one quarter-turn so that the arrow points to the “lock”

icon.

11: Turn the knurled knob clockwise to secure the lamp holder assembly.

12: Close the lamp housing door and turn the latch to secure the door.

CAUTION:

Use caution when installing or replacing any lamp.

When installing and replacing lamp, be sure to point the lamp away from

your face and away from others before inserting it firmly into the assembly.

This may prevent injuries if the lamp should break.

Note:

To avoid premature lamp failure, do not touch the lamp glass. If you do, clean it

carefully with isopropyl alcohol and a clean lint-free cloth. Allow to dry before

operation.

CAUTION:

Improperly installed lamps and lamp holder assemblies can cause premature

lamp failure and socket problems.

INCORRECTCORRECT

Adjusting the Field Angle 5

Adjusting the Field Angle

You can adjust the field angle of the fixture from 20° to 65° with the field angle adjustment knob.

1: Lift the locking lever to unlock the field angle adjustment knob.

Figure 4: Field angle adjustment knob and locking lever

2: Do one of the following:

• To reduce the field angle, turn the field angle adjustment knob counterclockwise.

• To enlarge the field angle, turn the field angle adjustment knob clockwise.

Figure 5: Field adjustment from flood to spot

3: To lock the field angle adjustment knob, press the locking lever into place.

CAUTION:

The field angle adjustment knob does not rotate 360°. Do not attempt to

exceed the rotation limit.

Locking lever

Field angle

adjustment knob

Field angle

adjustment

knob in flood

position

Field angle

adjustment

knob in spot

position

65° field angle

20° field angle

6Source Four Fresnel User Manual

Using Accessories

The accessory holder is equipped with two slots and a locking door that prevents color frames and

accessories from falling out.

Figure 6: Accessory holder door in the open position

Figure 7: Fixture with accessories

WARNING: Make sure all color frames and accessories are locked in position with the

accessory door before hanging the fixture.

Accessories such as barn doors and color scrollers must be secured with safety

cables to the mounting position, such as batten, truss, or other secure

structure.

Fixture should never be oriented so that the weight of the accessories, such

as color scrollers or barn doors, rests against the accessory holder door.

Accessory holder

locking door

Accessory

holder door

Accessory

Safety cables to

mounting

position

Acceptable Unacceptable

Altri manuali per source four fresnel

Indice

Altri manuali ETC Attrezzatura di illuminazione

ETC

ETC Echo Manuale utente

ETC

ETC Aero Wave Station Manuale utente

ETC

ETC Lustr+ Manuale utente

ETC

ETC Expression 2.0 Manuale utente

ETC

ETC High End Systems SolaPix 7 Manuale utente

ETC

ETC Source Four LED 3 Series Manuale utente

ETC

ETC fos/4 Series Manuale utente

ETC

ETC fos/4 Series Manuale utente

ETC

ETC microVision FX Manuale utente

ETC

ETC Source Four Revolution Rotating Wheel Module Manuale utente

ETC

ETC Irideon AR50 Manuale utente

ETC

ETC Source Four MultiPAR Manuale utente

ETC

ETC ArcLamp System Manuale utente

ETC

ETC GDS BluesSystem Manuale utente

ETC

ETC Source Four Revolution Scroller Cartridge Manuale utente

ETC

ETC Desire D40XTI Manuale utente

ETC

ETC Irideon WLZ Manuale utente

ETC

ETC Source Four Mini LED Manuale utente

ETC

ETC Sensor IQ Contact Input Control Option Card Manuale utente

ETC

ETC Hog 4 Series Manuale utente

ETC

ETC ArcSystem Pro One-Cell Series Manuale utente

ETC

ETC Desire Fresnel Manuale utente

ETC

ETC Source Four CE 405 Manuale utente

ETC

ETC ColorSource CYC Manuale utente

Manuali Attrezzatura di illuminazione popolari di altre marche

Brizo

Brizo 8SP-MU-4 Manuale utente

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manuale utente

IKEA

IKEA BJÖRKSPIREA Manuale utente

Laserworld

Laserworld Evolution Series ES-400RGB Manuale utente

Alien

Alien RG STAR Manuale utente

EuroLite

EuroLite LED B-40 Manuale utente

Qazqa

Qazqa Suplux SL 3 Black 103062 Manuale utente

Commercial Electric

Commercial Electric 54568141 Manuale utente

CREE LIGHTING

CREE LIGHTING 304 Series Manuale utente

Goobay

Goobay 49867 Manuale utente

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manuale utente

Alkalite

Alkalite Krypton KT-81 Manuale utente

Clas Ohlson

Clas Ohlson GU10 Manuale utente

DTS

DTS DELTA 10 F Manuale utente

ring

ring Solar Steplight Manuale utente

One Stop Gardens

One Stop Gardens 57696 Istruzioni per il montaggio

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manuale utente

SIREM

SIREM Swimeo A2 Manuale utente

ETC source four fresnel Manuale utente

Manuali Attrezzatura di illuminazione popolari di altre marche