The information in this document is subject to change without notice and describes only the product
defined in the body of this documentation. This documentation is intended for the use of
Eupen Cable USA, Inc. customers only for the purposes of product installation. The documentation
has been prepared to be used by professional and properly trained personnel, and the customer
assumes full responsibility when using it. Eupen Cable USA, Inc. welcomes any customer comments
or feedback. This product is suitable for outdoor use.
Eupen Cable USA, Inc. has made all reasonable efforts to ensure that the instructions contained in
this document are adequate and free of material errors and omissions.
The contents of this document are subject to revision without notice. Eupen Cable USA, Inc. shall
have no liability for any error damage of any kind resulting from the use of this document.
Disclaimer
Warnings
Please read this manual prior to use to become familiar with the product’s numerous features and
operating procedures. To maintain the maximum degree of safety, follow the sequences as outlined.
Before using this product, read all instructions and caution markings on any equipment connected
to this product.
CAUTION – Unless otherwise noted, product usage that is not recommended by the product
manufacturer can result in risk of fire, electric shock, or injury to persons.
CAUTION – Do not operate the product if it has been damaged in any way. Return damaged
products to manufacturer for repair or replacement.
WARNING – Disconnect or disable the DC power source to the product prior to beginning its
installation. Ensure that the DC power source to the product remains de-energized until the
completion of the installation and after all connections have been verified to be correctly configured.
ATTENTION – Installation of the hybrid cable requires an approved hanger to be used no more than
3 feet from the entrance of the junction box. Refer to Eupen Cable USA, Inc. installation guidelines
for proper hardware use and placement.
CAUTION – Do not bend fiber-optic cables beyond their minimum bend radius. Bending the fibers
beyond their minimum bend radius can damage the fibers.
CAUTION – Do not let fiber-optic cables hang free from the connector. All fiber must be secured
against movement in wind while maintaining enough slack to prevent any tension along the run.
Do not allow fastened loops of cables to dangle, which stresses the cables at the fastening point.
WARNING – Do not look directly into a fiber-optic transceiver or into the ends of fiber-optic cables.
Fiber-optic transceivers and fiber-optic cables connected to transceivers emit laser light that can
damage your eyes.
Page 2
For all comments or questions, please contact a Eupen Cable USA, Inc. representative at
(800) 419-5100 or www.eupen.us.
