Eventide TimeFactor Manuale utente
TimeFactor Initialization
Procedure:
1. Take the power supply and plug it into the wall first, plug the other end of the
power supply into the TimeFactor.
3. While the unit powers up, quickly push and hold down the encoder knob, the
left most knob in the lower row of knob controls and middle footswitch, labeled
“Repeat”. As soon as you see “INITIALIZING…” on the display, let go of the encoder
knob and middle footswitch. The unit will initialize the unit and then boot up as normal.
5. The unit is now initialized and the preset banks are unlocked.
To check if the unit is properly initialized:
1. Unplug the power supply from the unit to power it off.
2. Plug the power supply back into the unit to power it on.
3. Once the unit has been completely booted up, push and hold down the encoder
button and right footswitch, labeled “Tap”.
4. If done correctly, the display will read “BYPASS”. The LEDs above the left
and right footswitch will blink red.
5. Turn the encoder knob to the right until the display reads “UTILITY”.
6. Push the encoder knob down. The display will read “CATCHUP”.
7. Turn the encoder knob to the right until the display reads “SER#”.
8. Push the encoder knob down. If the display reads the serial number shown on
the back of the unit, the procedure was done correctly.
9. To exit bypass mode, repeat step 3, or cycle power in the unit by unplugging
the power supply from the back of the unit and plugging it back in.
Altri manuali per TimeFactor
2
Indice
Altri manuali Eventide Pedale musicale
Eventide
Eventide Space Manuale utente
Eventide
Eventide ModFactor Manuale utente
Eventide
Eventide H90 Harmonizer Manuale utente
Eventide
Eventide Harmonizer H910 Manuale utente
Eventide
Eventide MicroPitch Delay Manuale utente
Eventide
Eventide UltraTap Manuale utente
Eventide
Eventide ModFactor Manuale utente
Eventide
Eventide H3000 Ultra-Harmonizer Manuale utente
Eventide
Eventide Rose Manuale utente
Eventide
Eventide UltraTap Pedal Manuale utente
