EVERWhite Edison Series Manuale utente
Tools required:
• Hex Key (Supplied)
• Phillips Screwdriver (4x6 & 4x8 only)
Edison Series
Flip Board
Two person assembly recommended
Standard Parts:
Board
Knob
x2
Upright
x2
Spring Washer
x2
Tray
Socket Head Screw
x12
Crossbeam
Oval Cap
x6
Leg Assembly
x2
Round Cap
x8
F
A
G
B
H
C
I
D
J
E
www.everwhiteboards.com 800-335-7319
Note:
both sides of board.
Clean with a mild soap or glass cleaner.
Optional Parts For: 4'x6' and 4'x8' boards only.
Gusset
x2
K L
Self Tapping Screw
x4
Using Self Tapping Screws(L) and pilot holes to
attach Gussets(K) to frame
www.everwhiteboards.com 800-335-7319
1. Assemble Base(E) to Upright(B) using using Socket Head Screws(H). Tighten screws and repeat for opposite side.
2. Attach Crossbeam(D) to Base Assembly from Step 1 using Socket Head Screws(H).
Locking plates on Uprights should face the center. Tighten screws and repeat on other side.
3. Install Oval Caps(I) into the Base and Uprights. Do not install Round Caps until complete.
4. Place Spring Washer(G) on Board(A) post(2x). Spread Uprights and slide board into top holes of Uprights so locking
plates meet. Install Knobs(F) to secure board.
5. Attach Tray(C) to Base Assembly from Step 1 using Socket Head Screws(H). Tighten screws if gussets are not required.
6. If board is 4’x6’ or 4’x8’ install Optional Parts (K) and (L) on both sides. Tighten gusset and tray screws.
7. Verify all hardware is tight and install Round Caps(J) to cover all Socket Head Screws.
1.
2.
3.
3.
4.
5.
6.
7.
WARNING: Do not stand on or use as a step or climb.
Before moving board verify casters are unlocked.
Failure to follow warnings could cause injury.
ED
E
B
A
BC
K
K
4/19/2021
Indice
Altri manuali EVERWhite Lavagna bianca
