evolution fires VEGAS PETITE Manuale utente
OWNER’S MANUAL
VEGAS PETITE
WARNING
Read and understand this entire owner’smanual,includingall safety
information,beforeplugging in or using this product. Failure to do so could
result in fire, electric shock, or serious personal injury.
CAUTION Keep this owner’s manual for future reference. If you sell or give this
product away, make sure this manual accompanies this product.
Electric Fireplace
AC 110V-120V 50Hz 1500 W
SAVE THESE INSTRUCTIONS FOR
FUTURE USE.
CAUTION:
IF YOU USE THIS HEATER IN CONJUNCTION WITH A
THERMAL CONTROL A PROGRAM CONTROLLER A TIMER
OR ANY OTHER DEVICE THAT SWITHCHES THE HEATER
ON AUTOMATICALL Y REMEMBER TO OBSERVE ALL SAFETY
WARNINGS AT ALL TIMES. THE FIREPLACE HEATER HAS
SAFETY OVERHEAT PROTECTION. IF THE OVERHEAT
PROTECTION TRIPS SWITCH OFF ALL SWITCHES AND WAIT
A PPROXIMATELY 5 -10 MINUTES. IT SHOULD RESET
AUTOMATICALLY ONCE THE UNIT COOLS DOWN.
WARNING:
PROCEDURES AND TECHNIQUES IF NOT CAREFULLY
FOLLOWED WILL RESULT IN DAMAGE TO THE
EQUIPMENT,AND WILL EXPOSE THE USER TO THE RISK OF
SERIOUS INJURY,ILLNESS OR DEATH.THIS ELECTRIC
FIREPLACE HEATER IS FOR USE ON 120 VOLTS.THE CORD
HAS A PLUG AS SHOWN AT A IN ILLUSTRATION BELOW. AN
ADAPTER AS SHOWN AT C IS AVILABLE FOR CONNECTING
THREE BLADE GROUNDING TYPE PLUGS TO TWO SLOT
RECEPTACLES. THE GREEN GROUNDING LUG EXTENDING
FROM THE ADAPTER MUST BE CONNECTED TO A
PERMANENT GROUND SUCH AS A PROPERLY GROUNDED
OUTLET BOX. THE ADAPTER SHOULD NOT BE USED IF A
THREE SLOT GROUNDED RECEPTACLE IS AVAILABLE.
A 15 AMP CIRCUIT IS REQUIRED TO OPERATE THIS HEATER.
IF THE BREAKER TRIPS WHEN THE HEATER IS USED,YOU
MAY NEED TO MORE THE HEATER TO ANOTHER
LOCATION OR UNPLUG OTHER APPLIANCES THAT ARE ON
THE SAME CIRCUIT. IF YOU REQUIRE AN EXTENSION
CORD,USE ONE THAT IS RATED AT 175 WATTS.
@
a
✓
A B
700mm
300mm
Minimum Installation Height:
OPERATION
OPERATION WITH THE CONTROL PANEL
The unit will beep. Press again to decrease the flame
intensity. There are six light intensities to choose from. The
flame optics will go lower under the sequence of 6, 5, 4,
3 ,2 and 1. Press the button again to stop the flame effect.
750W:
Press this button for low heat level. The indicator
light wil l be ON. The heater will provide low heat level.
Press once again to stop the low heat level function.
1500W:
Press this button for high heat level. The unit
will beep. The heater will provide high heat level. Press
once again to stop the high heat level function.
OPERATION WITH THE REMOTE
CONTROL
1W
750W:
1500W:
Installation
Warning: Installing this product below 300mm will cause
overheating issues.
The suite is designed as a wall mounted suite; it is not suitable to be
installed at floor level.
This model is provided with a wall mounting bracket along with x5
screws and wall plugs.
PLEASE NOTE: The screws and plugs provided are only suitable
for a solid wall fixing.
If the installation is onto a hollow/stud wall, we recommend that
heavy duty wall anchors or equivalent are used.
To install the product:
Measure 700mm from the floor level up the wall, Mark this
measurement with a pencil.
Place the bottom edge of the wall bracket on the 700mm mark,
level using a spirit level and mark and drill the x5 fixing holes.
Using the correct wall fixings screw and fix the wall bracket in
place.
Locate the x3 slots in the rear of the product, carefully align these
slots with the prongs on the wall bracket, lift and slot the product
into place.
Locate the power cable socket on the bottom right hand side,
underneath the hearth on the fire, and plug the power lead in.
The product is now ready to use.
REMOTE CONTROL BAERY
REPLACEMENT
Replace with a CR2025 battery and follow the diagram at the
back of remote handset to install the new battery.
WARNING: DISCONNECT POWER AND UNPLUG THE
POWER CORD BEFORE ATTEMPTING ANY MAINTENANCE OR
CLEANING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK
OR PERSONAL INJURY.
To avoid bu ring of the skin, please turn off the heater and cool
down it for at least 10 minutes before maintenance.
CLEANING
To clean unit, first turn off the controls on the unit and unplug the
unit from power source.
To clean glass, remove dust with clean dry cloth or to remove
finger prints and other marks clean glass with clean damp cloth. Do
not use abrasive cleaners or spray liquids on the glass surface.
Metal and metal painted parts should be cleaned with a damp
cloth. Do not use abrasive cleaners or spray liquids on these surfaces.
STORAGE
When the heater is not in use, the heater should be stored in a dry
location, away from possible damage. The power cord should be
stored properly to avoid contact with hot or sharp objects.
Claims must be lodged within six 6 months of appearance of
defect. Failure to comply with this stipulation will make the
warranty null and void. We reserve the right to a thirty day 30
delay following receipt of claim in which to inspect the product.
We assume no responsibility for labor costs, removing/replacing a
previously installed product, transportation or return of a
product.
All claims must be reported immediately.
Please refer to our website www.evloutionfires.com to view our
full warranty/return policy.
EVOLUTION FIRES
11435 ROCKET BLVD
SUITE 108
ORLANDO
FLORIDA
32824
Phone number: 407 851 1536
Website: www.evolutionfires.com
Email: [email protected]
REPLACEMENT PARTS
WARRANTY
Every electric appliance is tested before it leaves the factory and it is
guaranteed for one year. If the unit should fail to operate correctly
within one year from the date of purchase, call customer service at
407 851 1536
We will, at our discretion either repair or replace the
unit. It will have to be returned to us freight prepaid and we will
return the repaired or replace unit to you freight prepaid. The
company's sole obligation is to repair or replace the unit. This
warranty is void if in the opinion of
Evolution Fires
the unit has
been tampered with, altered, misused,damaged, abused or used with
the wrong power source. The warranty is for homeowner use only
and does
not cover units used in commercial situations.
WARRANTY CLAIM PROCEDURE
If a claimable defect occurs, please contact our customer service
department at
407 851 1536
Before you make your claim call, please make sure you have:
IMPORTANT SAFETY INSTRUCTIONS
WHEN USING ELECTRICAL APPLIANCE BASIC PRECAUTIONS SHOULD ALWAYS BE FOLLOWED
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK AND INJURY TO PERSONS INCLUDING THE
FOLLOWING:
Read all instructions before using this electric fireplace.
Find a location for the electric heater that is protected from direct sunlight.
Do not plug the unit into the power outlet before reading all instructions.
This electric fireplace heater is hot when in use. To avoid burns do not let bare skin touch hot surfaces.
The grill directly in front of the heater outlet becomes hot during heater operation. Keep combustible
materials, such as: furniture, pillows, bedding, papers, clothes and curtains at least 3 feet away from the front
of the unit and keep them away from the sides and rear.
Extreme caution is necessary when any heater is used by or near children or individuals with disabilities and
whenever the fireplace is left operating and unattended.
Always unplug fireplace when not in use.
Do not operate any heater with a damaged cord / plug or after heater malfunctions or if it has been dropped or
damaged in any manner.
Do not use outdoors.
This heater is not intended for use in bathrooms, laundry areas and similar indoor locations.
Never locate heater where it may fall into a bathtub or other water container.
Do not run the power cord under carpeting. Do not cover cord with throw rugs, runners or similar coverings.
Arrange the cord away from traffic area and where it will not be tripped over.
To disconnect heater turn the controls to off then remove plug from outlet
Connect to properly grounded outlets only.
Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric
shock, fire or damage the heater.
To prevent a possible fire do not block air intakes or exhaust in any manner.
Do not use on soft surfaces like a bed where openings may become blocked.
A heater has no arcing or sparking parts inside. Do not use it in areas where gasoline, paint or flammable
liquids are used or stored.
Use this heater only as described in this manual.
Any other use not recommended by the manufacturer may cause fire, electric shock or injury.
Always plug heater directly into wall outlet or receptacle. Never use with extension cord or retractable power
bar outlet/power strip
Do not plug this product into a receptacle controlled by a wall switch or dimmer.
When storing or transporting the unit and cord keep in a dry place free from excessive vibration and store so
as to avoid damage.
PLEASE READ AND KEEP FOR FUTURE REFERENCE.
PLEASE NOTE:
PRIOR TO INSTALLATION WE ADVISE YOU TO INSPECT THE PRODUCT FOR ANY DEFECTS OR DAMAGE AND RECOMMEND THE
INSTALLATION BE CARRIED OUT BY A PROFESSIONAL INSTALLER.
EVOLUTION FIRES WILL NOT ACCEPT RESPONSIBIUIY FOR DAMAGE ONCE THE PRODUCT HAS BEEN INSTALLED.
PLEASE NOTE:
DO NOT DISPOSE OF YOUR CARTON UNTIL YOU ARE COMPLEIELY SATISFIED WITH YOUR NEW ELECTRIC FIREPLACE.
NOTE:The electric heater may emit a slight harmless odor when first turned on. This is caused by activating the internal heater components for the first
time and should not occur again. THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION.
Indice
Altri manuali evolution fires Camino da interno
evolution fires
evolution fires Vegas 96 Manuale utente
evolution fires
evolution fires Alpha Manuale utente
evolution fires
evolution fires VEGAS 72 Manuale utente
evolution fires
evolution fires 3 Sided Empire 72 Manuale utente
evolution fires
evolution fires 3 Sided Empire 44 Manuale utente
evolution fires
evolution fires SPECTRUM Series Manuale utente
