10 WT.050.810.020.DE.IM.0115
Safety Flow cell module DEPOLOX Pool E
2.2 General safety instructions
Evoqua Water Technologies GmbH attaches great importance to
ensuring that work on its device is always perfectly safe. This was
already taken into account in the design of the installation by the
integration of safety features.
Safety regulations The safety instructions in this documentation must be observed at
all times. Additional industry-wide or in-house safety regulations
also continue to apply.
Safety instructions on the
unit All safety instructions attached to the unit itself must be observed.
These instructions must always be clearly legible and complete.
State-of-the-art technology The unit has been constructed in accordance with state-of-the-art
technology and the accepted safety regulations. However, if the
unit is used by persons who have not been adequately instructed,
risks to life and limb of such persons or third parties and damage
to the unit itself or to other property cannot be ruled out. Work not
described in this instruction manual must be performed only by
authorized personnel.
Personnel The operator of the overall system must ensure that only
authorized and qualified specialized personnel are permitted to
work with and on the unit within their defined scope of authority.
“Authorized specialists” refers to skilled personnel employed by
the owner/operator or by Evoqua Water Technologies GmbH or, if
applicable, the service partner. Only qualified electricians must
perform work on electrical components.
Spare parts / components Trouble-free operation of the unit is only guaranteed if original
spareparts and componentsareusedinpreciselythecombination
described in this instruction manual. Failure to observe this
instruction may incur the risk of malfunction or damage to the unit.
Extensions and conversions Never attempt to perform any modifications, extensions or
conversionson the unitthatcouldhaveanadverse affect onsafety
without the written approval of the manufacturer.
Electrical power During normal operation, the controller must remain closed.
Connect the power cables in accordance with the wiring diagram.
