ALS: Alaska
HAI: Hawaii
ATL: Atlantic
EAS: Eastern
CEN: Central
MTN:Mountain
PAC: Pacific
Press the TIME ZONE Button
again to exit this mode. You
should hear two beeps indicat-
ing the TIME ZONE has been set.
Setting the Clock Time
and Calendar
To set the clock time, press
and hold the CLOCK button for
two seconds until the display
flashes. Turn the SETTING knob
(located on the right side of the
unit) until the correct time is
shown on the display. Press the
CLOCK button again to confirm
the time. You should hear one
beep indicating that the CLOCK
time is set.
The year on the lower right
display will flash. Turn the SET-
TING Knob to change it or press
the CLOCK button again to con-
firm the year. You should hear
one beep indicating that the year
is set.
The date on the lower right
display will flash. Turn the
SETTING knob to change it or
press the CLOCK button again to
confirm the date. You should
hear two beeps indicating that
the date is set.
Setting the Alarm Time
To set the alarm time, press
and hold the ALARM SET button
for two seconds until the display
flashes. Turn the SETTING knob
until the desired alarm time is
shown on the display. Be sure to
set your alarm time correctly to
the AM or PM time. A PM icon
will be shown on the right of the
time display. There is no AM
icon.
Press the WAKE TO button to
select your iPod, the radio or the
buzzer. A corresponding icon
will show on the top of the dis-
play. Press the ALARM SET but-
ton to confirm your settings.
You should hear two beeps indi-
cating the alarm is set.
Alarm Functions
The iBlaster Clock Radio fea-
tures a “SURE ALARM” func-
tion. If a power failure occurs of
the AC cord is accidentally dis-
connected, your alarm will not
be affected (provided you have
installed back-up batteries).
However, if back-up power is
used in the event of a power fail-
ure, the iBlaster Clock Radio
will default to the buzzer set-
ting.
This unit also features a
“GENTLE WAKING” function.
This means that when the alarm
is going off, it will gradually
increase in volume.
NOTE: To wake to your iPod,
your iPod must be properly
docked and off or the alarm will
not work.
First, set the alarm time as
described in the “Setting the
Alarm Time” section of this
manual.
You can change the sound you
want to wake to by pressing the
WAKE TO button.
Press the ALARM ON/OFF but-
ton to arm or disarm the alarm.
When the alarm is going off,
press the POWER OFF/ALARM
/RESET button on the iBlaster
Clock Radio or the POWER
ON/OFF button on the remote
control to turn the alarm off. The
alarm will go off again the next
day at the same time.
To stop the alarm from going
off the next day, press the
ALARM ON/OFF button to turn the
alarm function off. The ALARM
icon and the WAKE icon will dis-
appear from the display.
If the ALARM is not turned off
after it goes off, it will continue
to go off for approximately one
hour and then it will turn itself
off. This cycle will repeat every
24 hours unless the settings are
altered.
If you are waking up to an
iPod, make sure your iPod has
an hour’s worth of songs. If not,
set the iPod turn on your iPod
models REPEAT mode.
If you choose to wake to an
iPod but there is no iPod
installed, your iBlaster Clock
Radio will default to the buzzer.
Sleep Mode
To enter SLEEP mode, press
the SLEEP button on the iBlaster
Clock Radio. The unit will turn
off after the selected time.
SLEEP mode also features a
“GENTLE SLEEP” function,
which will gradually decrease
the volume if you are listening
to your iPod or the radio.
89
