Excelsior Excelair EOHA20GR Manuale utente
Outdoor Heater
Instruction Manual
Model EOHA20GR & EOHA20AR
IMPORTANT
Please carefully read the Operation Manual before using the infrared heater.
This Operation Manual contains the important information on your safety,
as well as some recommendations on proper use of the appliance and
its maintenance.
Page | 2
TABLE OF CONTENTS
CONTENTS PAGE 3
SAFETY INSTRUCTIONS PAGE 3-5
HEATER COMPONENTS PAGE 6
TECHNICAL SPECIFICATIONS PAGE 7
OPERATING THE HEATER PAGE 7-10
INSTALLATION-CEILING OR WALL MOUNT PAGE 11-16
TROUBLESHOOTING PAGE 17
WARRANTY INFORMATION PAGE 18
Page | 3
CONTENTS INCLUDED
§ Heater fitted with flexible cord and plug
§ Operating and Installation Instructions
§ One small box contains 1 set of Brackets
§ One Stainless Steel Frame bracket
§ One remote control
§
SAFETY INSTRUCTIONS
§ During use of the infrared heater, it is necessary to observe some
precautions. Improper operation with disregard of precautions may result in
infliction of harm to health of the user and other people, as well as in infliction
of damage to their property.
§ Use only the voltage specified on the rating plate of the heater.
§ ONLY connect the appliance to a properly installed socket-outlet with earth
contact.
§ The heater should be connected to the electric mains equipped with an
automatic circuit breaker.
§ The unit must be handled with care, and avoid vibration or hitting.
§ WARNING: FIRE RISK EXISTS IF THE HEATER IS COVERED BY OR
POSITIONED CLOSE TO CURTAINS OR OTHER COMBUSTIBLE
MATERIALS.
§ Do not use the appliance areas where gasoline, paint or other flammable
liquids are used or stored.
§ Do not use the appliance where explosives are stored.
§ Do not use the appliance in a building site, green house, barn or in animal
stables.
§ Do not use the appliance as a sauna heater.
§ WARNING: DO NOT TOUCH THE RADIATING PLATE. TEMPERATURE
OF RADIATING BOARDS DURING OPERATION OF THE HEATER MAY
REACH 380 °C.
Page | 4
§ To avoid burns, do not touch the appliance surface by hand and other body
parts. It is also necessary to avoid touching the heater whilst the appliance
is switched on, as severe burns may result. The appliance can take up to 1
hour to cool down after switching it off.
§ Do not place any items of clothing, hand towels or similar over the heater to
dry. Risk of overheating and fire hazard.
§ Do not leave the heater unattended whilst in use.
§ Do not use this heater on a wet surface, or where it can fall or be pushed
into water.
§ Do not reach for an appliance that has fallen into water. Switch off at supply
and unplug immediately.
§ If the heater is defective, it must be returned to the place of purchase.
§ Do not operate appliance with wet hands.
§ Use this appliance only as described in this manual. Any other use is not
recommended by the manufacturer and may cause fire, electric shock or
injury.
§ Do not use abrasive cleaning products on this appliance. If the body
becomes dirty, wipe off dust with a cloth, and the radiating boards should be
wiped when they are cold with a damp soft cloth. Always remove plug from
the mains supply before cleaning.
§ The heater must be installed at least 2.4 m above the floor.
§ The heater must not be located immediately below a socket-outlet. The
heater must not be located in front of a socket-outlet. They should be located
outside the physical footprint of the units to minimize heat build-up behind
the heater.
§ The installation must be equipped with a standard electrical power point with
a break contact distance of at least 3mm. The standard power point must be
installed by a licensed electrician.
§ If the heater is to be mounted on an incline (eg. Sloping or angled ceiling),
ensure the electrical connection is located at that lowest point of the heater.
§ Do not connect the appliance to the mains source until it has been installed
in its final location and adjusted to the position it will be used in.
Page | 5
§ Do not operate with the cord coiled up as this could cause a build-up of heat,
which could pose a hazard.
§ The use of an extension cord with this appliance is not recommended.
§ Do not allow cord to come in contact with heated surfaces during operation.
§ Do not run cord under carpeting, throw rugs or runners etc. Arrange cord
away from areas where it is likely to be tripped over.
§ This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
§ Children should be supervised to ensure that they do not play with the
appliance.
§ The appliance is only intended for the purpose described in user manual.
§ Do not use appliance or any part of the appliance out of the intended use to
avoid risk.
§ The use of attachments which are not recommended or sold by the
appliance manufacturer may cause a risk of injury to persons.
§ CAUTION — some parts of this product can become very hot and cause
burns. Particular attention has to be given where children and vulnerable
people are present.
§ Install and operate the heater in strictly horizontal position on the ceiling or
ceiling structural surface. The thermal resistance of the ceiling coating and
ceiling material should be at least 80 °C.
§ WARNING: This heater is not equipped with a device to control the room
temperature. This heater is to be used in open, alfresco environment or large
areas with high ceilings. The heater must not be within reach from the floor,
as severe burns may occur due to high surface temperatures. Do not use
this heater in small rooms or where the room or area is occupied by persons
not capable of leaving the room on their own, persons who are unable to
operate the heater safely and with the guidelines of the user manual, unless
constant supervision is provided.
Page | 6
§ WARNING: THE HEATER MUST NOT BE USED IF THE GLASS PANELS
ARE DAMAGED.
§ When the appliance is not in use and before cleaning, unplug the appliance
from the outlet.
§ To protect against the risk of electrical shock, do not immerse the unit, cord
or plug in water or other liquid.
§ The appliance is only intended for the purpose described in user manual. Do
not use appliance or any part of the appliance out of the intended use to
avoid risk.
§ The use of attachments which are not recommended or sold by the
appliance manufacturer may cause a risk of injury.
TECHNICAL SPECIFICATIONS
MODEL
EOHA20GR
EOHA20AR
Voltage
230-240V~, 50-60Hz
230-240V~, 50-60Hz
Power (W)
2000W
2000W
Installation
Wall or
Ceiling mounted
Wall or
Ceiling mounted
Product Size L*W*H (mm)
742 *110 *139
742 *110 *139
Insulation
Class 1
Class 1
Water Proof
IP65
IP65
Page | 7
INSTALLATION CEILING OR WALL MOUNT
2 Installation
2.1 Safe distances required for Wall-mounted installation
l Attention: The appliance must only be operated in a horizontal
position with max ±5°slope.
l Never install the appliance on a combustible surface (plastics,
nylon, carton etc.)
l Install the device at a minimum distance of
- 2.2 m above the ground
- 0.6 m from walls
- 0.24 m from the ceiling
- 1.5 m from the combustibles like curtains
- 1 m from persons or animals
Unit: (mm)
Page | 8
2.2 Safe distances required for Ceiling suspension installation.
Page | 9
2.3 Installation for wall mounted and ceiling mounted:
2.3.1 Install the fixing bracket on the wall or the ceiling, by 4 screws ST5
x 35mm (not supplied) and 4 plastic anchors (not supplied);
2.3.2 Select the desired angle, Insert the slot of the adjustable bracket,
on the stop of the fixing bracket;
2.3.3 Lock the fixing bracket and the adjustable bracket by 2pcs M6x16
Philips Bolt and wing nut;
Page | 10
CONNECTION TO ELECTRIC MAINS
• The heater is designed for connection to the single-phase 230-
240V~50-60Hz electric mains equipped with a earth.
• Before connection, make sure that specifications of the electric
mains at the connection point meet the single-phase 230-240V~50-
60Hz voltage.
• The electric mains should be equipped with an automatic circuit
breaker with rated current not less than 16A.
• The heater must not be located immediately below a power point.
Power point should not be located at the back of the heater. The
power point needs to be located outside the physical footprint of the
heater to minimize heat build-up behind the heater.
3. How to operate
Operation instruction：
①
"Ceramic glass panel
②
"ON/OFF main power switch
③
"Power cords and plug
④
"Brackets for wall or ceiling mounting
⑤
"Remote control
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali Excelsior Stufa
Manuali Stufa popolari di altre marche
Empire Heating Systems
Empire Heating Systems WCC65 Manuale utente
Wetekom
Wetekom 92 86 43 Manuale utente
Desa
Desa SPC170-F Manuale utente
Watlow
Watlow Watrod Electric Tubular Heaters Manuale utente
Haverland
Haverland ECO-DRY GPS Series Manuale elenco delle parti
Stelpro
Stelpro ASILVC2060 Series Manuale utente