2
SETTING UP AND USING YOUR HEATMITTS
Your HeatMitt PRO Heated Mittens are simple to set-up and use. Each pair comes supplied with individual
3.7 volt, lightweight miniature PowerPacks. (While a trickle charge may exist with each battery when
received, it is strongly recommended that both batteries be fully charged in accordance with the provided
directions before initial use.) Depressing the switch will light the LED to green, which indicates that power
is available and the unit is now on. To operate your HeatMitts, simply insert the mitten 1.3mm plugs into
the charged PowerPacks and then insert them into the integrated pockets.
To charge your HeatMitt PowerPacks, connect them to the supplied charger unit and plug them into a
standard electrical outlet. Please ensure that the PowerPacks are switched on when being charged. The
charger unit LED will light red until charging is complete, at which time the charger LED will change back to
green. The HeatMitt can then be unplugged and used normally. It will take several hours to charge the
PowerPacks fully, however a fast charge, offering several hours of heat, can be achieved after just one
hour of charging. DO NOT LEAVE CHARGING BATTERIES UNATTENDED.
Quick Charging Instructions
Plug-in the Dual Battery Charger to working electrical outlet, ensuring that the Charger LEDs are both
GREEN.
Turn the batteries ON and plug each into the Charger.
The Charger will read the charge level of each Battery individually. (One Charger LED may show green
while it is reading the other Battery.) THIS BATTERY IS NOT YET CHARGED.
Once the first Battery level is read, the second Battery will be read.
Allow the Batteries to remain charged, while in the ON position, for at least 6 hours OR until both
Charger LEDs have remained GREEN for at least 1 hour. The Charger LEDs will remain RED while
charging.
* The Battery LED color (GREEN) will not change.
