Explore Scientific RDC1008 Manuale utente
COMPACT RADIO CONTROLLED CLOCK WITH INDOOR TEMPERATURE S
OROLOGIO RADIOCONTROLLATO COMPATTO CON TEMPERATURA INTERNA
KOMPAKTER FUNKWECKER MIT INNENTEMPERATUR
HORLOGE RADIO-PILOTÉE COMPACTE AVEC TEMPÉRATURE INTÉRIEURE
RELOJ COMPACTO RADIOCONTROLADO CON TEMPERATURA INTERIOR
COMPACTE RADIOGESTUURDE KLOK MET BINNENTEMPERATUUR
ART.NO.:
RDC1008
IT ISTRUZIONI PER L’USO................
DE BEDIENUNGSANLEITUNG
............
EN INSTRUCTION MANUAL .............. 2
MODE D‘EMPLOI
FR
MANUAL DE INSTRUCCIONES
ES
NL MANUEEL INSTRUCTIE
....
...........................
...............
10
18
26
34
42
ABOUT THIS INSTRUCTION MANUAL
These operating instructions are to be considered a component of the device.
Please read the safety instructions and the operating instructions carefully before use.
Keep these instructions for renewed use at a later date. When the device is sold or given
to someone else, the instruction manual must be provided to the new owner/ user of the product.
The device is intended only for indoor use.
GENERAL WARNINGS
• Risk of electric shock — This device contains electronic components. Only use the device as de-
scribed in the manual; otherwise, you run the risk of an electric shock.
• Choking hazard — Children should only use the device under adult supervision. Keep packaging
material, like platic bags and rubber bands, out of the reach of children, as these materials pose a
choking hazard.
• Risk of chemical burn — Keep batteries out of the reach of children! Make sure you insert the ba-
tteries correctly. Leaking battery acid can lead to chemical burns. Avoid contact of battery acid with
skin, eyes and mucous membranes. In the event of contact, rinse the affected region immediately
with a plenty of water and seek medical attention.
• Risk of fire/explosion — Do not expose the device to high temperatures. Use only the recomme-
nded batteries. Do not short-circuit the device or batteries, or throw them into a fire. Excessive
heat or improper handling could trig-
ger a short-circuit, a fire, or an explosion.
• Do not disassemble the device. In the event of a defect, please contact your dealer. The dealer
will contact the Service Centre and can send the device in to be repaired, if necessary.
• Use only the recommended batteries. Always replace weak or empty batteries with a new, compl-
ete set of batteries at full capacity. Do not use batteries from different brands or with different
capacities. The batteries should be removed from the unit if it has not been used for a long time.
2
EN
IT
DE
FR
ES
NL
3
SCOPE OF DELIVERY
Clock, Operating instructions, 2x AAA batteries.
BEFORE YOU BEGIN
• We recommend using alkaline batteries. If temperatures regularly fall below 0°C (32°F), we rec-
ommend using lithium batteries.
• Avoid using rechargeable batteries. (Rechargeable batteries cannot maintain correct power req-
uirements.)
• Insert batteries before first use, matching the polarity in the battery compartment. 2x AAA Batt-
eries are required for the Clock.
PRODUCT OVERVIEW
1. Press [ SNZ / LIGHT ] to activate the backlight or to activate the snooze function to delay thealarm
for 5 minutes.
2. While in normal display mode, press [ ▼] to select °C or °F. While in setting mode, press
[ ▼ ] to decrease one unit, press and hold to decrease rapidly.
3. While in time setting mode, press [ ▲] to increase one unit, press and hold to increase
rapidly. While in alarm time checking mode, press [ ▲] to turn on/off the Alarm 1 or Alarm 2.
4. Press and hold [ ] to enter time and date setting mode.
5. Press [ ] to check the alarm time. Press and
hold [ ] to enter alarm setting mode.
6. Press [ ] to initiate or stop RCC receiving.
7. Battery compartment.
8. Table stand.
1
2
7
8
345 6
4
BUTTON
MODE SNZ/LIGHT
Stand-
ard
mode
PRESS
Turn on
backlight
SNOOZE
when
alarm is
ringing
HOLD
Time
setting
mode
PRESS _______
HOLD _______
Alarm
setting
mode
PRESS _______
HOLD _______
_______
Decrease
_______
_______
_______
_______
_______
Increase
Quick
Increase
Check
alarm
time
Enter into
alarm
setting
Select
°C or °F
▼▲
_______
Quick
Decrease
Decrease
Quick
Decrease
_______
Enter into
time and date
setting
Confirm
setting _______
_______
_______
Confirm
setting
Initiate
or stop
RCC
receiving
_______
_______
_______
_______
_______
5
EN
IT
DE
FR
ES
NL
Turn
Alarm 1
or
Alarm 2
on/off
_______
LCD DISPLAY
1. Time/Alarm display
2. Date and Month display
3. Day display
4. Indoor Temperature display
[ ] RCC signal indicator
[ ] Snooze indicator
[ ] Alarm
6
23 4
2
GETTING STARTED
INSERT BATTERIES
1. Remove the battery door from the back.
2. Insert 2x AAA (LR03)/1.5V batteries. Please ensure the polarities (+/-) of the batteries match
upon installation.
3. Reattach the battery door.
NOTE: Replace batteries when the display is dim.
CLOCK
CLOCK RECEPTION
1. When you insert or replace the batteries, RCC reception is initiated. To manually start RCC rece-
ption, press and hold the [ ] button.
2. If the RCC receiving process is successful, a completed RCC symbol [ ] will be shown in the
display and the date and time will be set automatically. If it fails, press and hold the [ ] button
to re-initiate RCC receiving.
3. If the device is still not receiving the signal, please proceed to set the time manually.
SET THE CLOCK MANUALLY
1. Press and hold [ ] button to enter into time and date setting.
2. The setting parameter will flash.
3. Press [ ▲] button once, the figure will increase 1 unit. Press and hold the [ ▲/CF ] button, the
figures will increase rapidly.
4. Press [ ▼] button once, the figure will decrease 1 unit. Press and hold the [ ▼/RCC ] button, the
figures will decrease rapidly.
7
EN
IT
DE
FR
ES
NL
5. Press [ ] button to confirm setting and enter to next parameter.
6. Sequence of setting: Year (2004-2054) Month Date 7 Languages Week Display
12/24HR Time Zone Hour Minute Exit
7. If there is no action in 30 seconds or If you press [ ] button, the setting will be saved and
you will exit the setting mode.
°C/°F SETTING
Press [▼ ] button to switch Celsius (°C) / Fahrenheit (°F).
ALARM
SETTING/ADJUSTING ALARM TIME
1. Press and hold [ ] button to enter alarm setting mode.
2. The setting parameter will flash.
3. Sequence of setting: Alarm 1 Hour Alarm 1 Minute Alarm 2 Hour Alarm 2 Minute Exit
4. Press [ ▲] or [ ▼] button to set the desired data.
5. Press [ ] button to confirm setting and exit.
6. Alarm will turn on automatically when alarm setting is finished.
TURN ON/OFF ALARM
Press [ ] to check the alarm time. Sequence of display: Alarm 1 Alarm 2
While in alarm time checking mode, press the [ ▲] button to turn on/off the Alarm 1 or Alarm 2.
8
SNOOZE FUNCTION
1. At the set time, alarm signal rings.
2. During the alarm, press the [ SNZ / LIGHT ] button to delay the alarm by 5 minutes.
3. To stop the alarm, press [ ] or any other button, except for [ SNZ / LIGHT ].
4. The alarm will start again at the next alarm time, unless you switch off the alarm function by
pressing the [ ] to choose Alarm 1 or Alarm 2 and then press [ ▲] button until the alarm is
set to off.
TEMPERATURE
The indoor temperature is always displayed in the right bottom corner of the screen.
BACKLIGHT
Press [ SNZ / LIGHT ] to activate backlight for 5 seconds.
SPECIFICATIONS
MAIN UNIT:
Dimensions
80 x 70 x 30 mm (L x W x H)
Weight
85 g (Exclude batteries)
Power:
2x AAA (LR03) 1.5V batteries
EN
IT
DE
FR
ES
NL
9
EC DECLARATION OF CONFORMITY
Hereby, Explore Scientific GmbH declares that the equipment type with part number:
RDC1008 is in compliance with Directive: 2014/53/EU. The full text of the EU declaration
of conformity is available at the following internet address: www.bresser.de/download
/RDC1008/CE/RDC1008_CE.pdf
NOTES ON CLEANING
• Remove the batteries before cleaning.
• Only use a dry cloth to clean the exterior of the device. To avoid damaging the electronics, do not
use any cleaning fluid.
• Protect the device from dust and moisture.
DISPOSAL
Dispose of the packaging materials properly, according to their type, such as paper or cardb-
oard. Contact your local waste-disposal service or environmental authority for information on
the proper disposal. Do not dispose of electronic devices in the household garbage!
As per the Directive 2002/96/EC of the European Parliament on waste electrical and electronic
equipment and its adaptation into German law, used electronic devices must be collected se-
parately and recycled in an environmentally friendly manner.
10
TEMPERATURE:
Indoor temperature display range:
-20°C to +50°C (-4°F to 122°F)
Indice
Lingue:
Altri manuali Explore Scientific Sveglia
Explore Scientific
Explore Scientific RPW3008 Manuale utente
Explore Scientific
Explore Scientific RDP3007-CM3000 Manuale utente
Explore Scientific
Explore Scientific RDC3006-CM3000 Manuale utente
Explore Scientific
Explore Scientific RDP1002 Manuale utente
Explore Scientific
Explore Scientific RDP1001-CM3000 Manuale utente
Explore Scientific
Explore Scientific RDC3006 Manuale utente
Explore Scientific
Explore Scientific RPW3008 Manuale utente
Explore Scientific
Explore Scientific RDC1005-CM3000 Manuale utente
Explore Scientific
Explore Scientific RDP3007 Manuale utente
Explore Scientific
Explore Scientific RPW3008-CM3000 Manuale utente
Explore Scientific
Explore Scientific NDC1004 Manuale utente
Explore Scientific
Explore Scientific RDP1003-CM3000 Manuale utente
Explore Scientific
Explore Scientific BCR2001 Manuale utente
Explore Scientific
Explore Scientific RDC1000 Manuale utente
Explore Scientific
Explore Scientific RDC1005 Manuale utente
Explore Scientific
Explore Scientific RDC1004-CM3000 Manuale utente
Explore Scientific
Explore Scientific RDC8001 Manuale utente
Explore Scientific
Explore Scientific RDP1001 Manuale utente
