EZ-ON 100TM Manuale utente
100TM
EMERGENCY RELEASE PROCEDURE
IMPORTANT INFO
• Meets FMVSS213.
• Use Only with EZ-ON Vests. Compatible Vest include: 303Z, 403PB.
• Install tether hardware kit if the passenger weight exceeds the vehicles tether anchor weight
determined by the vehicle manufacturer.
• Must use factory seatbelt.
• Use on school bus seats that have entry between the seat bottom and the seat back.
TETHER MOUNT (For Family Vehicle)
EMERGENCY CUTTING
When evacuating the passenger in a safety vest, the vest webbing is never cut. One cut of the mount
webbing above the anchor will allow the passenger to evacuate the vehicle wearing the safety vest
and one cut of the lap belt.
EZ-ON PRODUCTS 1-800-323-6598
www.ezonpro.com
WARRANTY
EZ-ON Products stands behind the products we make. Warranty covers any defects in material or workmanships under
normal use during the warranty period. We will repair or replace product defects for 1 year from manufacturer date.
WARNING
Death or serious injury can occur If manufacturer’s instructions are not followed correctly.
All EZ-ON products are dynamically tested to meet NHTSA standards. Please follow washing
instructions on product tag. Replace product if it is damaged, frayed, or has been in a crash.
Recommended replacement after six years.
EZ-ON Products are not liable for injury if these recommendations are not followed.
1-800-323-6598
www.ezonpro.com
INSTALLATION INSTRUCTIONS
1. Locate tether anchor bracket.
* Check vehicle owner’s manual to
locate factory installed tether bracket.
* Instructions for hardware kit are found in
the Tether Kit assembly bag.
2. Attach snap hook of tether mount to
car’s tether anchor.
3. Place the “Y” of tether mount over
back of the seat.
4. Tighten strap by pulling webbing
through tilt lock adjuster.
5. With passenger properly seated (hips
low against back of seat and shoulders
ush to seat). Attach each snap hook at
end of the “Y” to tether slots in shoulder
adjusters.
6. Reduce tether slack by lifting tilt lock
adjuster upward. Slide the webbing to
loosen or tighten.
* Passenger’s shoulders must be held
tight against back of seat.
7. Thread vehicle belt through vest loops.
8. Buckle belt low on the lap.
12
34
56
78
TETHER MOUNT
(For Family Vehicle)
100TM
EZ-ON PRODUCTS 1-800-323-6598
www.ezonpro.com
Indice
Altri manuali EZ-ON Accessori per automobili
