INSTALLATION INSTRUCTIONS
1. Unlock seat and lift up.
2. Hang shoulder strap from top of seat.
SECURING MOUNT STRAP
3. Wrap mount strap around seat
4. Connect push button. Face of push button
must be against bus seat back.
5. Tighten webbing by pulling down on the
excess webbing.
6. Webbing must be tight enough to create a
crease on the bus seat top.
7. Close seat bottom, with hip straps on the
seat bottom.
*Make sure all of the tilt adjusters are lying
at against the seat back.
8. Lock seat bottom in place.
9. Properly seat passenger (hips low against
the back of the seat and shoulders ush to
the seat).
10. Attach hip level tether hooks to the hip
level D-rings on EZ-ON Vest.
*Be sure that passenger has a properly
tted vest.
11. Tighten hip straps by pulling on the
webbing through the tilt adjuster on the back
side of the seat.
*Goal is to have the hip level d-rings to sink
into the seat bite.
12. Loop shoulder strap through D-ring at
shoulder level
13. Hook shoulder strap to D-ring on the
back of the seat.
14. Tighten shoulder strap by pulling on the
loose webbing.
*Repeat steps 12 – 14 for second
shoulder strap.
MAX II
EZ-ON PRODUCTS 1-800-323-6598
www.ezonpro.com
FOR SCHOOL BUS USE ONLY
123
456
78
10 11 12
13 14
9
