DH 11MX PRO English | 9
www.ffgroup-tools.com
f Exposure to noise can
cause hearing loss.
f
Loss of control can cause personal injury.
f-
Cutting accessory contacting a
“live” wire may make exposed metal parts of the
power tool “live” and could give the operator an
electric shock.
f Do not inhale the harmful
dusts generated in drilling or chiseling operation.
The dust can endanger the health of yourself and
bystanders.
fUnder normal operation, the machine is designed
to produce vibration, the screws and bolts can
come loose, causing a breakdown and accidents.
Check tightness of them carefully before running.
fIn cold weather or a long time tool not be used,
please keep the tool running without load a few
minutes to warm up the grease inside, otherwise
fBe sure you stand stably and no one is below when
you using tool is in high location.
f
fDon’t touch any moving parts.
fDon’t leave the tool running itself, operate tool
fDon’t point the tool to anybody for the bit could
fDon’t touch the bit or parts close to the bit imme
diately after operation, they may extremely hot
and could burn your skin.
fAny damage and abnormal happen, please stop to
use immediately and disconnect it, ask authorized
service center to check and repair.
f Only original parts can be used to
replace by authorized service center.
f Before connect
the power tool, please make sure the rated volt
age on the tool can match the power supply, oth
erwise the power tool may be damaged and cause
injuries.
f Solvent
such as gasoline, thinner, alcohol etc. these kind
of chemical material, are not allowed to use, wa
ter or soap are recommended!
fIn case of damages the replacement of the plug
or the supply cord shall always be carried out by
the manufacturer of the tool or his authorized
service.
fIf the replacement of the supply cord is necessary,
this has to be done by the manufacturer or his
agent in order to avoid a safety hazard.
f
Contact
shock. Damaging a gas line can lead to explosion.
Penetrating a water line causes property damage
or may cause an electric shock.
f
-
The power tool is guided more se
cure with both hands.
term exposure to vibration may cause temporary
or permanent physical injury, particularly to the
hands, arms and shoulders.
First be examined by a doctor and then have reg
lems are not being caused or worsened from
use. Pregnant women or people who have im
paired blood circulation to the hand, past hand
injuries, nervous system disorders, diabetes,
or Raynaud’s Disease should not use this tool.
If you feel any symptoms related to vibration
Use tools with the lowest vibration when there
is a choice.
work.
Make sure the power supply information on the
machine’s rating plate are compatible with the
power supply you intend to connect it to.
This appliance is Class II and is designed for con
nection to a power supply matching that detailed
on the rating label and compatible with the plug
proved and compatible lead rated for this appli
ance. Follow all the instruction supplied with the
extension lead.
Double insulated: This product requires no earth
connection as supplementary insulation is applied
to the basic insulation to protect against electric
shock in the event of failure of the basic insula
tion.
fMake sure your extension cord is in good condi
tion. When using an extension cord, be sure to
use one heavy enough to carry the current your
product will draw. An undersized cord will cause a
drop in line voltage resulting in loss of power and
overheating.
fAlways replace a damaged extension cord or have
fProtect your extension cords from sharp objects,
fUse a separate electrical circuit for your tools. This
circuit should be protected with the appropriate
to the power line, make sure the switch is in the
OFF position and the electric voltage is rated the
same as the voltage stamped on the motor name
plate. Running at a lower voltage will damage the
motor.
