09. Program the Optional Features
Follow the steps below to program the optional features:
a.
Turn the ignition on then off with the RS500 deactivated.
b.
Within 10 sec., press the valet switch three times.
c.
The hazard lights will be on for 1 sec. to confirm the module is in programming mode.
d.
Within 10 sec., press the valet switch the same number of times as the option No. you wish to program.
e.
The hazard lights will flash the same number of times as the item being selected to confirm the selection.
g.
Then, press and hold the valet switch and the hazard lights will flash 1-4 times as per the optional features.
h.
Release the valet switch when the hazard lights have flashed the same number of times as the desired feature.
i. Press the valet switch 1-5 times to select the next item for programming.
* During the programming mode, if the valet switch is not pressed within 10 sec. or the ignition is turned on then the
system will leave the programming mode and the hazard lights will flash once to confirm.
10. Explanation of the Optional Features
#1 Engine Sense Mode
Default: Alternator (auto-sense)
When set as: Tach
Connect W2-7 to the ignition coil(-). RPM learning has to be performed as follows before initial operation:
a.
Turn off all the devices such as Stereo, Radio, and air conditioning etc.
b.
Shift the gear to neutral or parking position (and pull up the handbrake).
c.
Switch the ignition on, start the engine and release the footbrake until idling.
d.
Press and hold the valet switch for 2 sec. when the tachometer (rev counter) is about 800rpm and the LED is on.
e.
Release the valet switch when the hazard lights turn on to confirm the RPM learning is completed.
* If the LED is still off when the tachometer is about 800rpm then turn the V.R. until the LED is just on.
#2 Cranking Time
Default: 600ms
If the engine doesn’t start smoothly, then set the crank time longer.
#3 Engine Running Time
Default: 10 minutes
The engine will run for 10, 20 or 30 minutes as programmed and then shut down automatically.
#4 Turbo Timer
Default: Disable
The turbo timer will not be activated.
When set as: 2 or 3 minutes
a.
The engine will continue to run for 2 or 3 minutes (depending on setting) after the ignition is turned off.
b.
The operation is as follows:
- Keep the engine running.
- Pull up the handbrake.
- Turn the ignition key to the off position, the ACC. and ignition circuits will stay on for 2 or 3 minutes as
programmed and then shut down automatically.
* The turbo timer is functional only when the engine has been running for at least 10 sec.
c.
The turbo timer mode will be interrupted if any of the following occurs:
- The wire W2-7 shows a ground input.
- The wire W2-8 shows +12V.
- The wire W3-4 shows a negative pulse.
#5 Timer Start
Default: 4 hour
The engine will start automatically every 4 hours.
When set as: 12 or 24 hour
The engine will start automatically every 12 or 24 hours as programmed.
The setting (4, 12 or 24 hours) of timer start has to be turned on as follows before initial operation .
- Switch the ignition on then off
- Press and hold the valet switch within 10 seconds of switching the ignition off and release after the hazard
lights
have flashed twice to confirm the timer start feature is turned on. The system starts to count time (4, 12 or 24
as programmed).
* Repeat above steps to turn on the timer start feature if the footbrake has been tapped or handbrake has been
released with the engine running.
