SAFETY INSTRUCTIONS
ATTENTION –AThis manual contains important safety instructions that must be followed
during installation and maintenance of the equipment.
KEEP THIS MANUAL
READ THE MANUAL –EKeep this document in a safe place for easy access at all times
during installation and maintenance.
THE INSTALLER MUST READ THIS DOCUMENT IN ITS ENTIRETY BEFORE INSTALLING THE
EQUIPMENT
READ THE MANUAL –EOperators are required to read this manual and to comply strictly
with the instructions it contains.
FIMER cannot be held responsible for damage caused to persons and/or property, or to the equipment,
if the conditions described below have not been complied with.
The purpose of this document is to support qualified technicians, who have received appropriate
training and/or have demonstrated adequate skills and knowledge in the construction, installation,
operation and maintenance of electrical equipment.
The warranty requirements are contained in the Terms and Conditions of Sale section included with
the purchase order for this product.
NOTE –DAny modification not approved by FIMER will immediately invalidate the
product warranty.
WARRANTY AND DELIVERY CONDITIONS
The warranty conditions are considered valid if the customer complies with the instructions contained
in this manual; any deviation from the warranty conditions with respect to what is described below
must be expressly indicated in the purchase order.
FIMER declares that the equipment complies with the legal provisions currently in force in the country
of installation and has issued the relative declaration of conformity.
FIMER assumes no responsibility for failure to comply with the instructions for proper installation and
cannot be held responsible for the systems upstream or downstream of the equipment supplied.
It is absolutely forbidden to modify the equipment. Any modification, manipulation or alteration of the
hardware or software not expressly agreed with the manufacturer will immediately void the warranty.
Due to the large number of possible combinations of system configurations and installation
environments, it is essential to check the following before installing the product: adequate space for
housing the equipment, ambient noise produced by the environment and possible flammable
conditions.
FIMER cannot be held responsible for defects or malfunctions deriving from: improper use of the
equipment; deterioration due to transport or particular environmental conditions; incorrect or
insufficient maintenance; tampering or unsafe repairs; use or installation by unqualified persons.
FIMER is not responsible for any disposal of the equipment, or part of it, that does not comply with
the regulations and laws in force in the country of installation.
