STATISTICTS DISPLAY AND MANUAL (CONTINUOUS)
DEACTIVATION
Press and hold the C1 and the C2 button until you hear four beeps and the display says
“STATS”. Press C1 and “ON”will be displayed. To turn ”OFF” press C2 (if you want to turn selection
back to “ON” press M). To continue and store this value press C1 again and then “MAN” will appear.
Press the C1 again until you see “ON”. You can change it to “OFF”by pressing C2. Once you have done
this, confirm and exit this menu by pressing C1.
If you choose to turn off statistics display (rolling headline showing D,U,and L values), the values will
continue to be stored but information will not be shown.
TIME AND WEEK ADJUSTMENT
To adjust the time press and hold the C1 button and the M button simultaneously. Using two
hands will ensure proper operation. You will hear two beeps followed by time display flashing.
Adjust hours- up with M button, down with C2 button. Advance to the next setting with the C1
button once time values are adjusted. Next you will arrive at the week day setting. The days of
the week are assigned a value such as follows:
Mon = 1 Tues = 2 Wed = 3 Thurs = 4 Fri = 5 Sat = 6 Sun = 7
Please note that time is only numeric (24 hours)
Safety devices-Thermal cut off
This grinder is equipped with and thermal cut off sensor. If your grinder becomes jammed with a
foreign object and the burrs are no longer spinning, the power to the motor will be disconnected
to avoid damage if overheating occurs. The burrs may become jammed if you adjust to the
coffee too fine. If this occurs please disconnect grinder from the power supply, loosen the burrs,
and wait till grinder cools off (approximately 15 minutes). NEVER try to release whatever is
jammed in the burrs while the machine is plugged in. It is possible for the grinder burrs to start
rotating if you try to remove whatever is blocking the burrs while the machine is on. This could
cause personal injury. Please contact technical assistance if problem persists.
