7. Assess a position for the required Fireco Repeater
to be installed, i.e. not within 1 metre of a power source
or metal surface (including Georgian wire-glass).
8. Move your Fireco Survey Transmitter to this new
position and repeat the first steps of the survey until you
have a positive radio range reading at each door you
require to be held open with Dorgard Pro.
Repeat this process for all of the doors you wish to cover. If at
a door position the Dorgard Pro gives a red LED indicating it is
no longer in range of the Survey Transmitter, the installation will
require a Fireco Repeater to be located at the end of the range.
4. Place the Survey Dorgard Pro at the position a
Dorgard Pro is to be fitted. Ensure you hold it at
the bottom of the fire door with the rubber foot
touching the floor. Press the plunger down to get a
radio reading. If the Dorgard Pro is in range of the
Survey Transmitter the top LED of the Dorgard Pro
will flash green for 4 seconds. If the Survey Dorgard
Pro is no longer in range it will flash the top LED
red for 4 seconds.
6. To identify a suitable location for the new Repeater bring
the Survey Dorgard Pro closer to the Survey Transmitter
until you are again in range (confirmed by getting a green
light on the top LED of the Survey Dorgard Pro after you
press the plunger down).
!Do
Page 6
Survey
