Firestone Sonoma Manuale utente
FINAL ASSEMBLY
STEP #1 The Sonoma should be in your
desired location.
STEP #2 Slide the Firebox back into the unit.
The unit is correctly installed when the back of
the rock is flush with the stucco finish
STEP #3 Have a qualified licensed profes-
sional make all the gas connections at this time.
This should be done in accordance to all local
and national codes.
STEP #4 Slide the Hearth Pad into place
evenly.
STEP #5 Install the gas burner. Directions are
included in the gas log box.
STEP #6 Install the logs and accessories as
detailed in the provided instructions
Fire Stone Home Products
12400 Portland Avenue South
Burnsville, MN 55337
phone (952) 358-7438 | fax (952) 358-7414
www.firetonehp.com
SONOMA
OWNER’S MANUAL
INSTALLATION INSTRUCTIONS
Contents__________________________
Contents……………………………….…………2
Required Tools….……………………………….3
Unwrapping.……………………………………..4
Step One (Removal of Hearth Pad)…………..….5
Step Two (Removal Fire Box)…..………………6
Step Three (Mount Top Shelf)…………………..7
Final Assembly…………...……………………..8
MOUNTING THE SHELF
Step #3
Mounting Holes
1. Remove the 3/8” x 1-1/2” bolts from the
back of the shelf.
2. One person holding the shelf in place and
the other person inside the Sonoma thread
the bolts back into the inserts. DO NOT
OVER TIGHTEN OR LIFT FROM THIS
SHELF
1. Using a power drill remove all of the brown
painted screws to dislodge the firebox.
2. With a minimum of two people slide the
firebox out completely and set aside.
3. This is a good time to move the Sonoma
into it’s final place.
WARNING
FIREBOX WEIGHT IS 150-175 LBS.
Step #2
3 Painted
Screws
REMOVAL OF FIREBOX REQUIRED TOOLS
⇒Razor Knife
•To cut and remove packaging.
⇒Hammer or Pry Bar
•To remove 1 x 2 and staples.
⇒Power Drill or Philips Screw Driver
•To remove packaging screws.
⇒9/16” Deep Socket or Standard
Socket with Extension
•To attach the top shelf
⇒Leather Gloves
•To protect hands from rough and sharp
products found on the Sonoma.
⇒It is recommended that a minimum of two
people assemble and install the Sonoma.
UNWRAPPING PROCEDURE
WARNING
THE CAST TOP OF THE SONOMA IS
NOT ATTACHED. DO NOT SLIDE
OR MOVE THE UNIT UNTIL THIS
HAS BEEN REMOVED.
1. Carefully dissect the outside wrapping to
expose the unit. Maintain control of the
blade the product behind could be damaged.
2. Remove the 1 x 2’s so the unit is more eas-
ily removed from the pallet.
3. Remove the cast top with a minimum of
two people and set aside.
4. Remove the top shelf and burner assembly
from the firebox. This is more easily done
one at a time.
1. Slide the removable Hearth Pad out with
care at an even rate. DO NOT FORCE
OR BIND THE PAD AGAINST THE
FIREBOX.
REMOVAL OF THE HEARTH PAD
Hearth Pad
Step #1
Indice
Altri manuali Firestone Camino da interno
