SAFETY INSTRUCTIONS:
•FIRST BASIC heating panels are designed for wall and ceiling installation.
•Each panel is equipped with a set of special brackets that, when used properly, provide a secure installation.
•The appliance is safe to touch and will not cause burns from very quick contact with the heated glass. Prolonged contact with the
heated glass can cause injury.
•Small children should not be left unattended near the heating panel, as prolonged contact with the heated panel may cause injury.
•The appliance is suitable for use in the bathroom. However, direct contact with water must always be avoided (see heating panel
installation).
•If any object or liquid enters the panel, unplug the panel immediately and have it checked by a qualified First Heating Systems
service technician before using it again.
•The appliance is equipped with a silicone power cable with grounding, which must be used with standard earthed sockets. If the
power cord or the appliance is damaged, contact FIRST Heating Systems as it must be repaired by a specialist.
•DO NOT disassemble the appliance. Disassembly will void the warranty. Disassembly and reassembly must not be performed
outside the factory or a specialized service center.
•TO REDUCE RISK OF ELECTRIC SHOCK, always unplug the power cord if a fault is detected, or if the panel needs to be moved.
•PROTECTION AGAINST OVERHEATING AND FIRE HAZARD: The front glass panel can reach a surface temperature of up to
150°C. Do not place flammable substances or objects in front of the panel. The surface temperature of the back cover at 220V-
250V reaches 85-112 ° C. For installation and electrical installation in plasterboard, etc., seek an electrician or specialist.
•Installation on flammable materials is prohibited.
•CLEANING: ALWAYS disconnect the panel from the power supply before cleaning; never clean it when it is connected to the
power supply.
•WARNING: To prevent the panel from overheating, do not cover the heating panel with anything!
FOR FIRST USE:
•If you notice an odor after turning it on, it is likely that the new heating element is heating up. If the odor persists after 1 hour of
operation, turn off the panel, locate and remove the odor source. If the odor persists for 2 days, contact your dealer.
•The panel MUST NEVER be placed directly under an electrical socket! Position the panel so that the power cord plug is next to
the panel.
•The panel MUST NEVER BE USED if the glass is damaged! If the glass is damaged, contact your dealer.
•FIRST panels are designed to withstand a slight overvoltage of 220 - 250V, depending on the area where they are used.
Before use, make sure that the panel you are installing is suitable for your area. If this is not the case, do not plug the
appliance into an electrical outlet and contact your supplier. If the panel is plugged into an outlet with the wrong voltage or the
voltage fluctuations exceed the above range, the warranty of FIRST Heating Systems does not cover such damage.
