Fisher & Paykel OR36SDBMX1 Istruzioni operative

How to Use the Top Burners

Gas Burners (Triple-ring and Semi-

rapid)

Gas flow to the burners is adjusted by turning the dials

(illustrated in fig. 2.1) which control the valves.

Turning the dial so that the symbols printed on the dial

point to the mark on the bezel achieves the following

functions:

https://producthelp.fisherpaykel.com/us/Cook/Ranges/Gas/OR36SDBMX1/User_Guide_OR36SDBMX1/04_how_to_use_the_…

Updated: Thu, 11 Nov 2021 19:59:30 GMT

Fig.

2.1

Dial Position Function Semi-Rapid Burner Triple-Ring Burner

OFF Closed valve

Maximum rate

LO Minimum rate

The maximum dial setting permits rapid boiling of liquids, whereas the

minimum dial setting allows simmer warming of food or maintaining

boiling conditions of liquids.

To reduce the gas flow to minimum, rotate the dial further counter-

clockwise to point the indicator towards the LO position (minimum rate).

Other intermediate operating adjustments can be achieved by

positioning the indicator between the maximum and minimum dial

settings. Never operate the burners with the dial set between the HI and

OFF positions.

https://producthelp.fisherpaykel.com/us/Cook/Ranges/Gas/OR36SDBMX1/User_Guide_OR36SDBMX1/04_how_to_use_the_…

Updated: Thu, 11 Nov 2021 19:59:30 GMT

When the range is not being used, set the gas dials to their OFF positions. If the range will

not be used for an extended period of time, it is recommended that the gas shut off valve in

the main supply line be closed.

Lighting Gas Burners fitted with Flame Failure

Safety Device (Triple-Ring and Semi-Rapid

Burners)

In order to light the burner, you must:

1. Push and turn the dial in an counter-clockwise direction to

the HI position (maximum rate), push in and hold the dial

until the flame has been lit (fig. 2.2).

The sparks produced by the electrode situated inside the

relative burner will light the flame.

In the event that the local gas supply conditions makes it

difficult to light the burner in HI position (maximum rate), try

again with the dial in LO position (minimum rate).

2. Wait for about ten seconds after the gas burner has been lit

before letting go the dial (safety device activation delay).

3. Adjust the gas valve to the desired position.

If there is no mains electrical supply, the burners can be used with

no restriction. In that case, in order to light the burner, you must:

1. Bring a lighted match close to the burner (as per side figure)

and keep it in place until the burner has been ignited.

2. Push and turn the dial in an counter-clockwise direction up to

the HI position (maxi- mum rate), push in and hold the dial

until the flame has been lit (fig. 2.2).

In the event that the local gas supply conditions makes it

difficult to light the burner in HI position (maximum rate), try

again with the dial in LO position (minimum rate).

3. Wait for about ten seconds after the gas burner has been lit

before letting go the dial (safety device activation delay).

4. Adjust the gas valve to the desired position.

If the burner flame should go out for some reason, the safety valve will automatically stop the gas flow.

To re-light the burner, return the dial to the closed OFF position, wait for at least 1 minute and then repeat the lighting

https://producthelp.fisherpaykel.com/us/Cook/Ranges/Gas/OR36SDBMX1/User_Guide_OR36SDBMX1/04_how_to_use_the_…

Updated: Thu, 11 Nov 2021 19:59:30 GMT

procedure.

If your local gas supply makes it difficult to light the burner with the dial set to maximum, set the dial to minimum and

repeat the operation.

The range becomes very hot during operation. Keep children well out of reach.

Gas Burners (Dual)

The Dual Burner is a very flexible burner which allows

different regulations for optimal cooking.

It is composed by one inner and one outer crown; the flame

of the inner crown can be regulated separately from the

flames of the outer crown.

The Dual Burner can be used:

• As a high-power burner (all flames produced

simultaneously by inner and outer crown) which can be

adjusted from the maximum (

) to the minimum (

) position.

Intermediate operating adjustments can be achieved by

positioning the indicator between the maximum and

minimum dial settings. Never operate the burner with the

dial set between the and OFF positions.

• As a small burner (flame produced only by the inner

crown) which can be adjusted from the maximum (

) to the minimum (

) position.

https://producthelp.fisherpaykel.com/us/Cook/Ranges/Gas/OR36SDBMX1/User_Guide_OR36SDBMX1/04_how_to_use_the_…

Updated: Thu, 11 Nov 2021 19:59:30 GMT

Fig. 2.3 Fig. 2.4

Gas flow to the burners is adjusted by turning the dials (illustrated in fig. 2.3) which control the valves.

Turning the dial so that the symbols printed on the dial point to the mark on the bezel achieves the following functions:

https://producthelp.fisherpaykel.com/us/Cook/Ranges/Gas/OR36SDBMX1/User_Guide_OR36SDBMX1/04_how_to_use_the_…

Updated: Thu, 11 Nov 2021 19:59:30 GMT

Dial

Position Function DUAL Burners

OFF Closed valve

Maximum rate of inner + outer crown (inside and outside

flames in simultaneously at the maximum).

Minimum rate of outer crown and maximum rate of inner

crown.

Maximum rate of inner crown (only inner flame at the

maximum).

Minimum rate of inner crown (only inner flame at the

minimum).

Lighting Gas Burners fitted with Flame Failure Safety Device (Dual Burner)

In order to light the burner, you must:

1. Push and turn the dial in a counter-clockwise direction to the

https://producthelp.fisherpaykel.com/us/Cook/Ranges/Gas/OR36SDBMX1/User_Guide_OR36SDBMX1/04_how_to_use_the_…

Updated: Thu, 11 Nov 2021 19:59:30 GMT

position (maximum rate of inner + outer crown); push in and hold the dial until the flame has been lit (fig. 2.4).

The sparks produced by the electrode situated inside the relative burner will light the flame.

In the event that the local gas supply conditions makes it difficult to light the burner in position

, try again with the dial in position

2. Wait for about ten seconds after the gas burner has been lit before letting go the dial (safety device activation

delay).

3. Adjust the gas valve to the desired position.

If there is no mains electrical supply, the burners can be used with

no restriction. In that case, in order to light the burner, you must:

1. Bring a lighted match close to the burner (as per side

figure) and keep it in place until the burner has been

ignited.

2. Push and turn the dial in a counter-clockwise direction up

to the

position (maximum rate of inner + outer crown); push in

and hold the dial until the flame has been lit (fig. 2.4).

In the event that the local gas supply conditions makes it

difficult to light the burner in position

, try again with the dial in position

3. Wait for about ten seconds after the gas burner has been

lit before letting go the dial (safety device activation delay).

4. Adjust the gas valve to the desired position.

If the burner flame should go out for some reason, the safety valve will automatically stop the gas flow.

To re-light the burner, return the dial to the closed OFF position, wait for at least 1 minute and then repeat the lighting

procedure.

If your local gas supply makes it difficult to light the burner with the dial set to maximum, set the dial to minimum and

repeat the operation.

https://producthelp.fisherpaykel.com/us/Cook/Ranges/Gas/OR36SDBMX1/User_Guide_OR36SDBMX1/04_how_to_use_the_…

Updated: Thu, 11 Nov 2021 19:59:30 GMT

When the range is not being used, set the gas dials to their OFF positions. If the range will

not be used for an extended period of time, it is recommended that the gas shut off valve in

the main supply line be closed.

The range becomes very hot during operation. Keep children well out of reach.

Fig 2.5

Choice of Burner (fig. 2.5)

The symbols or wordings printed on the panel above the gas dials

indicate the correspondence between the dial and the burner.

The most suitable burner is to be chosen according to the diameter and

volume capacity of the container to be warmed.

It is important that the diameter of the pots or pans suitably match the

heating potential of the burners in order not to jeopardize the efficiency of

the burners, bringing about a waste of gas fuel.

A small diameter pot or pan placed on a large burner does not necessarily

mean that boiling conditions are reached quicker.

Diameters of Pans which May be Used on the Hob Burners

Burner Minimum Max.

Semi-rapid 16 cm (6” 19/64) 24 cm (9” 7/16)

Triple-ring and Dual 26 cm (10” 3/16) 28 cm (11” 1/16)

Wok pans min 36 cm (14” 3/16) - max 40 cm (15” 3/4)

Do not use pans with concave or convex bases

https://producthelp.fisherpaykel.com/us/Cook/Ranges/Gas/OR36SDBMX1/User_Guide_OR36SDBMX1/04_how_to_use_the_…

Updated: Thu, 11 Nov 2021 19:59:30 GMT

Fig 2.6a

Correct Use of Dual Burner (Fig. 2.6a - 2.6b)

The flat-bottomed pans are to be placed directly onto the pan-support.

When using a WOK you need to place the supplied wok support on

the pan support for the burner to avoid any faulty operation of the

Dual burner (Figs. 2.6a - 2.6b).

The special support for wok pans (figs.

2.6b, 2.6c) MUST BE PLACED ONLY

over the pan-rest for the Dual burner.

Fig 2.6c

https://producthelp.fisherpaykel.com/us/Cook/Ranges/Gas/OR36SDBMX1/User_Guide_OR36SDBMX1/04_how_to_use_the_…

Updated: Thu, 11 Nov 2021 19:59:30 GMT

Fig 2.6b

Ensure that the handles of cookware do not stick out over the edge of the range, to avoid

them being knocked over by accident. This also makes it more difficult for children to reach

the cooking vessels.

https://producthelp.fisherpaykel.com/us/Cook/Ranges/Gas/OR36SDBMX1/User_Guide_OR36SDBMX1/04_how_to_use_the_…

Updated: Thu, 11 Nov 2021 19:59:30 GMT

Altri manuali per OR36SDBMX1

Altri manuali Fisher & Paykel Allineare

Fisher & Paykel

Fisher & Paykel OR30S Manuale utente

Fisher & Paykel

Fisher & Paykel OR30SDG6X1 Manuale utente

Fisher & Paykel

Fisher & Paykel OR36SDG Manuale utente

Fisher & Paykel

Fisher & Paykel OR36SCG4 Manuale utente

Fisher & Paykel

Fisher & Paykel 7 Series Manuale utente

Fisher & Paykel

Fisher & Paykel OR36LDBGX1 Manuale utente

Fisher & Paykel

Fisher & Paykel OR90SCG6B1 Manuale utente

Fisher & Paykel

Fisher & Paykel RGV3-366 Manuale utente

Fisher & Paykel

Fisher & Paykel OR36SDBGX Manuale utente

Fisher & Paykel

Fisher & Paykel OR36SDBMX Manuale utente

Fisher & Paykel

Fisher & Paykel OR30SDBMX Manuale utente

Fisher & Paykel

Fisher & Paykel OR30S Gas Gas Manuale utente

Fisher & Paykel

Fisher & Paykel DCS RGS Series Manuale utente

Fisher & Paykel

Fisher & Paykel OR36SCG Manuale utente

Fisher & Paykel

Fisher & Paykel RDV3-488 Manuale utente

Fisher & Paykel

Fisher & Paykel Freestanding range Manuale utente

Fisher & Paykel

Fisher & Paykel CG604CLPX2 Manuale utente

Fisher & Paykel

Fisher & Paykel RHV3 Series Manuale utente

Fisher & Paykel

Fisher & Paykel OR48DDPWGX Manuale utente

Fisher & Paykel

Fisher & Paykel OR36SDBGX Manuale utente

Fisher & Paykel

Fisher & Paykel OR90SDBGFX3 Manuale utente

Fisher & Paykel

Fisher & Paykel OR30SDPWGX Manuale utente

Fisher & Paykel

Fisher & Paykel RGT-305 Manuale utente

Fisher & Paykel

Fisher & Paykel OR48DDPWGX Manuale utente

Manuali Allineare popolari di altre marche

Samsung

Samsung FCQ321HTUW Manuale utente

Kenmore

Kenmore 790.45712 Manuale utente

Wolf

Wolf CHR CHSSR Manuale utente

Smeg

Smeg Built-in Microwave Oven Manuale di istruzioni

Zanussi

Zanussi ZCG054G Manuale utente

Whirlpool

Whirlpool 8575985-W Manuale elenco delle parti

Frigidaire

Frigidaire 316000635 Manuale utente

GE JCSS630 Manuale utente

Samsung

Samsung NX58M9960P series Manuale utente

Hotpoint

Hotpoint RB524R Guida all'installazione

Whirlpool

Whirlpool Roper FGP305KW3 Manuale utente

Amana

Amana ART6610 SERIES Manuale utente

Maytag

Maytag MERH770WB Manuale utente

Fulgor Milano

Fulgor Milano SOFIA Manuale utente

Premier

Premier EF-4358GH Manuale utente

Kenmore

Kenmore 790.9010 Series Manuale utente

KitchenAid

KitchenAid KESC300 Manuale utente

Frigidaire

Frigidaire FFEF3012LS Guida utente