Fishman PRO-EQ Manuale utente
PRO-EQ
ACOUSTIC INSTRUMENT
PREAMP/ EQUALIZER
OWNER’S MANUAL
Thank you for your purchase of a FISHMAN product. Please read these
instructions carefully. If you have any questions or problems, contact our
PRODUCT INFORMATION LINE at 978-988-9665.
AC POWER
The PRO-EQ is powered at all times when using an AC Adapter.
Always be
sure to use only the Fishman 910-R or Roland PSA Series AC Adapters!
Use of any other AC Adapter may cause permanent damage to the unit.
BATTERY POWER
To install the battery, unscrew the four corner screws and remove the back
of the case. Flip the battery lead outside of the case and connect a 9 volt
alkaline battery. Place the battery on the foam pad. Replace the back of the
case and securely fasten the four screws.
The AMP output jack of the PRO-EQ is the power switch for the battery.
When a cable is first plugged into this jack, the BATTERY/LOW LED will
flash momentarily to indicate that the power is on. When the battery power
is low, this LED will remain lit, indicating that you should replace the bat-
tery. To avoid battery drain, be sure to unplug the cable from the AMP jack
when it is not in use.
PHASE
Adjust the volume control of the PRO-EQ and your amplifier to the desired
level. Using your ears as a guide, set the PHASE switch for proper relation-
ship with the sound source (amps, monitors, etc.). The correct phase setting
will provide a tighter response with less tendency to feed back. This rela-
tionship is most audible at louder volumes and will change from room to
room and with your position on stage.
EQUALIZATION
The PRO-EQ features fully active BASS, MIDDLE, TREBLE and BRIL-
LIANCE controls; allowing boost and cut. The BASS and TREBLE sliders
are shelving style controls and the MIDDLE and BRILLIANCE controls are
resonant style.
PRO-EQ
2
SUB-BASS CONTROL
On the back of the unit there is a recessed SUB-BASS con-
trol which is set flat at the factory. This feature can be used
to emphasize the amount of “bottom end” on small-bodied
guitars by turning it clockwise.
USER OPTIONS
For live performance, the enclosed belt clip may be attached to the back of
the unit with the two screws provided.The belt clip should not cover the
SUB-BASS control. For free-standing use, affix the adhesive-backed rubber
feet to the corners of the unit.
SPECIFICATIONS
Measured with all tone controls at center detent and volume at max.
Nominal Input Level: -20 dBV
Input Overload: (20 Hz to 20 kHz) 0 dBV
Input Impedance: 10 M
Ω
Output Impedance: Less than 3.5 k
Ω
Nominal Output Level: -17 dBV
THD: .2% @ 1 kHz,-20dBV input
Signal to Noise Ratio: 79 dB (A weighted, referred to
nominal -20 dBV input)
Current Drain: Less than 9 mA
Power Supply: 9V alkaline battery (estimated 55 hours
continuous use) Regulated 9V AC Adapter
Sub-Bass Control: 0 to +10 dB at 80 Hz
Bass Control Range: ± 11dB at 60 Hz
± 3 dB at 350 Hz
Middle Control Range: ± 8 dB at 1.25 kHz
± 3 dB bandwidth:1.5 kHz
Treble Control Range: ± 11dB at 10 kHz
± 3 dB at 2.4 kHz
Brilliance Control Range: ± 9 dB at 9 kHz
± 3 dB bandwidth: 7 kHz
Dimensions: 5 1/8" X 3" X 1 3/16"
All specifications subject to change.
ACOUSTIC INSTRUMENT PREAMP/EQUALIZER
3
LIMITED WARRANTY
The FISHMAN PRO-EQ is warranted to function for a period of One (1) Year from the date
of purchase. If the unit fails to function properly within the warranty period, free repair and
the option of replacement or refund in the event that FISHMAN is unable to make repair
are FISHMAN’s only obligations.This warranty does not cover any consequential damages
or damage to the unit due to misuse, accident, or neglect. FISHMAN retains the right to
make such determination on the basis of factory inspection. Products returned to
FISHMAN for repair or replacement must be shipped in accordance with the Return Policy,
as follows. This warranty remains valid only if repairs are performed by FISHMAN. This
warranty gives you specific legal rights and you may also have other rights which may vary
from state to state.
RETURN POLICY
To return products to FISHMAN TRANSDUCERS, you must follow these steps...
1. Call FISHMAN TRANSDUCERS at 978-988-9199 for a Return Authorization Number
(“RAN”).
2. Enclose a copy of the original Bill of Sale as evidence of the date of purchase, with
the product in its original packaging and a protective carton or mailer.
3. FISHMAN TRANSDUCERS’ technicians will determine whether the item is covered by
warranty or if it instead has been damaged by improper customer installation or other
causes not related to defects in material or workmanship.
4. Warranty repairs or replacements will be sent automatically free of charge.
5. If FISHMAN TRANSDUCERS determines the item is not covered by warranty, we will
notify you of the repair or replacement cost and wait for your authorization to
proceed.
FISHMAN TRANSDUCERS
®
340-D Fordham Road Wilmington MA 01887 USA
Phone 978-988-9199 • Fax 978-988-0770
www.fishman.com
009-068-001 1-97
Altri manuali per PRO-EQ
2
Indice
Altri manuali Fishman Amplificatore
Fishman
Fishman Aero Plus Manuale utente
Fishman
Fishman POCKER BLENDER Manuale utente
Fishman
Fishman ELLIPSE AURA - Manuale utente
Fishman
Fishman PREFIX STEREO BLENDER Manuale utente
Fishman
Fishman Prefix Pro blend Manuale utente
Fishman
Fishman PREFIX - PREAMP INSTALLATION GUIDE REV 4 Manuale utente
Fishman
Fishman ACOUSTIC BASS BLENDER Manuale utente
Fishman
Fishman AURA PRO RETAIL Manuale utente
Fishman
Fishman PRESYS PLUS Manuale utente
Fishman
Fishman PREFIX PLUS Manuale utente
Fishman
Fishman PREFIX PLUS-T - SCHEMA Manuale utente
Fishman
Fishman AGP-2 Manuale utente
Fishman
Fishman LOUDBOX ARTIST Manuale utente
Fishman
Fishman SA Sub Manuale utente
Fishman
Fishman Loudbox Manuale utente
Fishman
Fishman ELLIPSE AURA RETAIL Manuale utente
Fishman
Fishman LOUDBOX ARTIST Manuale utente
Fishman
Fishman Fluence Stephen Carpenter Signature Manuale utente
Fishman
Fishman Loudbox Performer Manuale utente
Fishman
Fishman PREFIX PREMIUM BLEND Manuale utente
