Flash EVENT Series Manuale utente

LED PAR 7x40W

ZOOM IP65

User Manual

Instrukcja Obsługi

Art No F7100334

SERIES: EVENT

CONTENTS

INTRODUCTION 3

SAFETY INFORMATION 3

PRODUCT INFORMATION 4

INSTALLATION 4

CONNECTION 5

DMX CHART 8

WARNING! Use clamp to rig the xture.

WARNING! When clamping the xture to a truss or other structure at

any other angle than with the yoke hanging vercally downwards, use two

clamps of half-coupler type. Do not use any type of clamp that does not

completely encircle the structure when fastened.

WARNING! Posion or shade the bar so that the front lens will not be

exposed to sunlight or any other strong light source from any angle - even

for a few seconds. See Figure 1. The LED PAR lens can focused the sun’s

rays, creang a potenal re hazard and causing damage.

IMPORTANT! Do not point strong light output from other xtures at the

LED PAR, as intense illuminaon can damaged the display.

Figure 1.

Pages: 2-9

Strony: 10-16

INTRODUCTION

SAFETY INFORMATION

THANK YOU FOR PURCHASING LED PAR. FOR SAFETY REASONS

AND TO ENSURE THE TROUBLE-FREE OPERATION, CAREFULLY

READ THE INSTRUCTIONS.

Please keep this User Manual

for future consultaon. If you sell

the xture to another user, be sure

that they also receive this instruc-

on booklet.

Unpack and check carefully the-

re is no transportaon damage be-

fore using the xture.

Before operang, ensure that

the voltage and frequency of po-

wer supply match the power

requirements of the xture.

It’s important to ground the

yellow/green conductor to earth

in order to avoid electric shock.

Disconnect main power before

servicing and maintenance.

Use safety chain when xes this

xture. Don’t handle the xture by

taking its head only, but always by

taking its base.

Maximum ambient temperature

is: 40°C Don’t operate it where the

temperature is higher than this.

In the event of serious ope-

rating problem, stop using the

fixture immediately. Never try

to repair the fixture by your-

self.

Repairs carried out by unskil-

led people can lead to damage

or malfunction. Please contact

the nearest authorized techni-

cal assistance center. Always

use the same type spare parts.

Do not connect the device

to any dimmer pack.

Do not touch any wire during

operation and there might be a

hazard of electric shock.

To prevent or reduce the risk

of electrical shock or fire, do

not expose the fixture to rain

or moisture.

The housing must be repla-

ced if they are visibly damaged.

Do not look directly at the li-

ght spot while the fixture is on.

PRODUCT INFORMATION

INSTALATION

Light Source:

7x40W RGBW LED’s

Power consumpon: 300W

Power supply voltage:

100-240V, 50/60Hz AC

Macros (Color, Color + Zoom)

Zoom 3.5°-55°

Operang modes: DMX512,

Manual, Auto, Sound-controlled,

Master/Slave, Sound acve,

DMX channel mode

6/12

IP Rang: IP65

Housing made: Aluminium

Cooling: Acve

AC IN/OUT: Tru1Con

3-Pin XLR DMX Input/Output

Net Weight: 8 kg

Gross weight: 8,2 kg

Net Dimensions:

H(40 with handle)

xW(27)xD(20) cm

Pack Size:

H(50)xW(23)xD(23) cm

The unit should be mounted via

its screw holes on the bracket.

Always ensure that the unit is

firmly fixed to avoid vibration

and slipping while operating.

Always ensure that the structu-

re to which you are attaching

the unit is secure and is able

to support a weight of 10 ti-

mes of the unit’s weight. Also

always use a safety cable that

can hold 12 times of the we-

ight of the unit when installing

the fixture. The equipment must

be fixed by professionals. And it

must be fixed at a place where is

out of the touch of people and

has no one pass by or under it.

The fixture may be installed in

any orientation, but if installed

horizontally with a downward

beam-angle, water can poten-

tially pool in the fan wells. Under

normal operation the moisture

will evaporate. However, in loca-

tions with high rainfall, you may

wish to fabricate a rain shield

above the fixture, or modify the

position and orientation of the

fixture to minimize pooling.

Two quarter-turn brackets are

supplied with the fixtre if it is

to be flown above the ground.

Rig the fixture to a support truss

or structure using the supplied

brackets and suitable clamps.

Fasten a safety cable between

the support structure and the

attachment point on the fixture.

The safety cable must be able to

bear at least 10 times the weight

of the fixture.

CONNECTION

The device is equipped with the following interfaces:

1. DMX (in/out): XLR 3(5)-pin socket

2. Power (in/out): Tru1CON socket

The connecon is performed using cable with

XLR-female -> XLR-Male plugs.

SHIELD

SIGNAL (+)

SIGNAL (-)

FEMALE

XLR

MALE

XLR

SHIELD

SIGNAL (+)

SIGNAL (-)

FEMALE

XLR

MALE

XLR

CAUTION! At the last xture, the

DMX signal has to be terminated

with a terminator. Solder a 120Ω

resistor between signal (-) and si-

gnal (+) into a XLR plug and plug

it in the DMX output of the last

xture.

3-PIN XLR

5-PIN XLR

The package includes:

❶ - LED PAR (1 pc)

❷ - Power cable type

Tru1CON (1 pc)

❸ - User Manual (1 pc)

❹ - Omega bracket (1 pc)

❶

❷

❸

❹

User

Manual

Using lamp, the change rate of power voltage should be within ±10%,

if the voltage is too high, it will shorten the light’s life.

Input Voltage Frequency Total Power

100-240[V] AC 50/60[Hz] 300[W]

Voltage Specicaon.

Control Menu

DMX

Controller DMX 512 DMX 512 120

Diagram of connecon of devices by DMX cable.

IMPORTANT! The maximum number of devices connected

in series via power cable is 5 pcs.

The connecon is performed using power cable with powerCON con-

nector (included). The device must be operated by qualied personnel.

CAUTION! In the case of cable damage do not aempt to repair. Repla-

cement or repair can be made only on the manufacturer or by a person

with appropriate permissions

UP DOWN ENTER

DISPLAY

No 6 CH 12 CH

1Red Dimmer

2 Green Dimmer Fine (16 bit)

3Blue Strobo

4 White Macro Auto Programm

001-005 Empty

006-040 Prog 1

041-080 Prog 2

081-120 Prog 3

121-160 Prog 4

161-200 Prog 5

201-240 Prog 6

241-255 Empty

5Zoom Macro Programs Speed

6Zoom Fine (16 bit) Red

7 Green

8Blue

9 White

10 CTO

11 Zoom

12 Zoom Fine (16 bit)

DMX CHART

SPIS TREŚCI

WPROWADZENIE 11

INFORMACJE DOTYCZĄCE BEZPIECZEŃSTWA 11

INFORMACJE O PRODUKCIE 12

INSTALACJA 12

POŁĄCZENIE 13

TABLICA DMX 16

OSTRZEŻENIE! Do zamocowania urządzenia należy użyć zacisku.

OSTRZEŻENIE! Podczas mocowania urządzenia do kratownicy lub innej

konstrukcji pod innym kątem niż z jarzmem zwisającym pionowo w dół, na-

leży użyć dwóch zacisków typu półzłącza. Nie używaj żadnego typu zacisku,

który nie otacza całkowicie konstrukcji po zamocowaniu.

OSTRZEŻENIE! Przednia soczewka nie powinna być narażo-

na na działanie światła słonecznego lub innego silnego źródła świa-

tła pod jakimkolwiek kątem - nawet przez kilka sekund. Patrz

Rysunek 1. Soczewka LED PAR może skupiać promienie słoneczne, stwa-

rzając potencjalne zagrożenie pożarem i powodując uszkodzenia.

WAŻNE! Nie należy kierować silnego światła z innych urządzeń na LED

PAR, ponieważ intensywne oświetlenie może uszkodzić wyświetlacz.

Rysunek1.

Altri manuali per EVENT Series

Indice

Lingue:

Altri manuali Flash Attrezzatura di illuminazione

Flash

Flash FOLLOW SPOT 350W Manuale utente

Flash

Flash FL-233 BEAM Manuale utente

Flash

Flash F7300235 Manuale utente

Flash

Flash LED WASHER RGB IP34 ver.II Manuale utente

Flash

Flash F7200204 Manuale utente

Flash

Flash F7100323 Manuale utente

Flash

Flash F7100331 Manuale utente

Flash

Flash F7100523 Manuale utente

Flash

Flash F7100070 Manuale utente

Flash

Flash LOGO Manuale utente

Flash

Flash F7100335 Manuale utente

Flash

Flash FTB-324-2 Manuale utente

Flash

Flash LED NEW EFFECT LIGHT Manuale utente

Flash

Flash 7X40W BIG EYE PRO Manuale utente

Flash

Flash LED PAR 18x10W RGBW 4in1 IP20 Manuale utente

Flash

Flash LED BIG-EYE KALEIDOSCOPE Moving Head 19x15W Osram... Manuale utente

Flash

Flash F7300231 Manuale utente

Flash

Flash F7000560 Manuale utente

Flash

Flash F7000050 Manuale utente

Flash

Flash F7100330 Manuale utente

Flash

Flash F7100250 Manuale utente

Flash

Flash 8R BEAM Manuale utente

Flash

Flash F7100511 Manuale utente

Flash

Flash LED PAR 56 SLIM RGB Aura F7000253a Manuale utente

Manuali Attrezzatura di illuminazione popolari di altre marche

Brizo

Brizo 8SP-MU-4 Manuale utente

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manuale utente

IKEA

IKEA BJÖRKSPIREA Manuale utente

Laserworld

Laserworld Evolution Series ES-400RGB Manuale utente

Alien

Alien RG STAR Manuale utente

EuroLite

EuroLite LED B-40 Manuale utente

Qazqa

Qazqa Suplux SL 3 Black 103062 Manuale utente

Commercial Electric

Commercial Electric 54568141 Manuale utente

CREE LIGHTING

CREE LIGHTING 304 Series Manuale utente

Goobay

Goobay 49867 Manuale utente

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manuale utente

Alkalite

Alkalite Krypton KT-81 Manuale utente

Clas Ohlson

Clas Ohlson GU10 Manuale utente

DTS

DTS DELTA 10 F Manuale utente

ring

ring Solar Steplight Manuale utente

One Stop Gardens

One Stop Gardens 57696 Istruzioni per il montaggio

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manuale utente

SIREM

SIREM Swimeo A2 Manuale utente