P9
2.5 Simple commands
Command list Purpose Default
Setting Example
PH2 XX,SS Sets the primary number for voice
interrupt and SOS reporting. No default
PH2 XX,SS where XX is the primary phone
number and SS will be the number of seconds set
to listen in. PH2 without the number, will disable
this feature.
PH2 0412345678 will set the primary number to
0412345678
SPEED KKK To notify the primary identity when the
Speed limit is exceeded. Default is off SPEED KKK where KKK is the speed in Kmh.
SPEED 00 disables Speed alerts.
SPEED 65 will trigger when the speed of vehicle
goes over 65kmh.
LOCATION LOCATION command when sent alone will report the current location.
PDS=TIME
[seconds],DIST[meters]
Eg., PDS=60,100 means that the PT will report every 60 seconds in case it travels 100 Meters. This will make is easy for you and will fit in with the parameters your device
supports.
INI A,B,C,D,E,F,G
A DEVCODE
B APN OF THE NETWORK PROVIDER
C USERNAME OF THE NETWORK PROVIDER, BLANK IF NOT REQUIRED
D PASSWORD OF THE NETWORK PROVIDER, BLANK IF NOT REQUIRED
E SERVER IPADDRESS.
F SERVER PORTADDRESS.
G TO TOGGLE 3 VALUES I.E 1,2,3 THEREFORE,
G1 REPORTING VIASMS ONLY
G2 REPORTING VIA GPRS ONLY
G3 REPORTING VIABOTH
