—6—
Electric Belt Cutter
General Safety Rules
!WARNING
Always use belt cutter on a level, rm surface.
Cutting is only allowed when operating the
machine with one hand on the handle and the
other on the hammer-drill. Before starting the
machine, the handle must be installed on either
the right or le side.
!CAUTION
Do not force tool.
!WARNING
Do not use tool if switch does not turn it on or
o. Any tool that cannot be controlled with the
switch is dangerous and must be repaired.
!WARNING
Disconnect the plug from the power source
before making any adjustments, changing
accessories, or storing the tool. Such
preventive safety measures reduce the risk of
starting the tool accidentally.
!WARNING
Store idle tools out of reach of children and
other untrained persons. Tools are dangerous in
the hands of untrained users.
!CAUTION
Maintain tools with care. Keep cutting tools
sharp and clean. Properly maintained tools, with
sharp cutting edges are less likely to bind and are
easier to control.
!CAUTION
Check for misalignment or binding of moving
parts, breakage of parts, and any other condition
that may aect the tool’s operation. If damaged,
have the tool serviced before using. Many
accidents are caused by poorly maintained tools.
!WARNING
Tool service must be performed only by
qualied repair personnel. Service or
maintenance performed by unqualied
personnel could result in a risk of injury.
!CAUTION
When servicing a tool, use only identical
replacement parts. Use of unauthorized parts or
failure to follow Maintenance Instruction may
create a risk of electric shock or injury.
!DANGER
Do not use power tools if the plastic housing or
handle is cracked. Cracks in the tool’s housing
or handle can lead to electric shock. Such tools
should not be used until repaired.
!CAUTION
Do not wipe plastic parts with solvent. Solvents
such as gasoline, thinner, benzene, carbon
tetrachloride, and alcohol may damage and
crack plastic parts. Do not wipe them with such
solvents. Wipe plastic parts with a so cloth
lightly dampened with soapy water and dry
thoroughly.
!WARNING
NEVER use a tool which is defective or
operating abnormally. If the tool appears to
be operating unusually, making strange noises,
or otherwise appears defective, stop using it
immediately and arrange for repairs.
!WARNING
Before performing any belt cutter maintenance,
remove the plug from the socket and follow all
procedures noted in manual.
