Flexcom Reachfar V20 Manuale utente
Flexcom Communication Ltd Installation and operating instructions (2021/03/24)
1/25
Installation and operating instructions
Reachfar V20 vehicle tracker device
Introduction
In developing the products we offer, the manufacturers have acted with the utmost care and in
accordance with international standards.
Warranty
We offer a 12-month warranty on the products, which is valid from the date of purchase. Keep the
invoice or block you received at the time of purchase and / or the warranty card of the device,
because you can only enforce your warranty claim if you have them. During the warranty period, we
will replace any defective main unit, accessory or software of the product in the event of any defect
attributable to a manufacturing, material or software defect. Subsequent repairs to the device or its
accessories are not permitted by the manufacturer due to the design of the device.
The warranty does not cover a product (or accessory) that has been damaged or rendered inoperable
due to attempts to modify or repair the software, physical impact, poor voltage, improper use.
To ensure proper, effective and safe use of the product, read the instruction manual carefully and
keep it for future reference. Flexcom Kommunikációs Kft. Shall not be liable for any damage, product
damage, short-term or long-term health damage that may occur as a result of use, repair, storage
and transport other than those described in this manual.
Rights, trademarks
© 2019, Flexcom Kommunikációs Kft.
All rights reserved. No part of our printed or online publications may be reproduced, distributed or
transmitted in any form or by any means, including photocopying, recording or other electronic and
mechanical methods, without the prior written permission of the publisher. To obtain a permit,
contact your dealer:
Contact
Flexcom
Flexcom Communication Ltd Installation and operating instructions (2021/03/24)
2/25
Flexcom Communication Ltd.
2151 Fót, Szent Imre str. 94. HUNGARY
Email: [email protected]
Website: https://nyomkovetes.net
Office
2151 Fót, Dózsa György str. 34. HUNGARY
Phone: +36 1 769 1005
Mobile 1: +36 70 3333 525
Mobile 2: +36 70 3333 527
Phone service: (Monday-Thursday) 9.00–15.00
Every effort has been made to ensure that the information in our documents is accurate. Flexcom
Kommunikációs Kft. Is not responsible for typographical errors and misspellings.
Flexcom GPS Tracking Solutions, GPS Positioning System, Nyomkovetes.net is a registered trademark
and domain name of Flexcom Kommunikációs Kft. In Hungary. Other company and product names
mentioned herein may be trademarks of their respective companies.
Protection of personal data
The product is a complete product as a combination of hardware and software components. For safe
and correct use, proceed as described in this manual during installation and use. Keep the device or
software out of the reach of unauthorized persons. Our company provides all technical and regulatory
conditions to ensure that data management complies with legal requirements and that your data does
not fall into unauthorized hands. We accept no liability for damage resulting from unauthorized use of
the product and software.
Flexcom
Flexcom Communication Ltd Installation and operating instructions (2021/03/24)
3/25
Formats and notations
The following style settings are used in descriptions, guides, and other documents:
Bold text Name of product components, instructions, options, processes, services, user interface
elements.
Italic text Links to other publications, emphasis.
Courier text System messages, internet addresses, document names.
Warning and cautionary signs:
Tips, advice, ideas.
Document download option.
General attention to information about the product or its operation.
Indication of situations with a lower risk to the user or the product (minor injuries,
inconveniences).
Indication of situations which present a higher risk to the user (serious injury, possibly
death) or which may cause damage or destruction of the product.
Flexcom
Flexcom Communication Ltd Installation and operating instructions (2021/03/24)
4/25
Product Description
The device combines several functions of accurate positioning, safety, monitoring, emergency alarms
and full tracking. It supports SMS / GPRS / Internet data transfer functions, it can be widely used in the
field of location-based services and personal security.
The device is designed by the manufacturer to track people or objects or packages - as a result, its
users are primarily persons and owners. The included accessories allow the user of the device to
quickly set up, position or remove. The device can be operated with the SIM card of any GSM service
provider.
Settings that affect the operation of the device can only be changed from another device
(smartphone, computer) using the appropriate application or SMS commands - so users can be sure
that the device always works according to the parameters they specify.
Flexcom
Flexcom Communication Ltd Installation and operating instructions (2021/03/24)
5/25
How to use
You can use the device after charging, inserting the SIM card, and setting it up via SMS or a mobile
phone or PC application. The device automatically connects to the GPS and GSM networks using the
GPS receiver and the SIM card (if available) and starts collecting position data, which can be queried
using SMS or an Internet application.
The device can be used after setting up and inserting the SIM card via SMS or a mobile phone or PC
application. Once turned on, the GPS receiver and SIM card will automatically connect to the GPS and
GSM networks (if available) and start collecting position data. You can activate or deactivate various
functions via SMS by sending commands to the device or by using an Internet application, and you
can receive data from it in the same way.
After inserting the SIM card and charging the battery, you can make the necessary settings by
sending an application or SMS (eg entering the device ID name, frequency of sending GPS position
data, etc.).
When switched on
The device continuously registers position data, which can be queried with SMS commands at a
limited level.
If you have a software subscription, the device sends the position data to the software service
center - the processed results (eg map route display, route event list, real-time tracking) - can
be viewed in the phone or computer application.
The device can also be used as an energy bank to charge other devices or as a lamp.
You will find detailed information on the installation, use, maintenance and decommissioning of the
device in the following sections of the documentation.
Flexcom
Flexcom Communication Ltd Installation and operating instructions (2021/03/24)
6/25
Flexcom
Flexcom Communication Ltd Installation and operating instructions (2021/03/24)
7/25
Technical parameters
Physical characteristics
Parameter Value
Dimensions (mm) W: 51, L: 122, H: 25
Weight (g) 130
Humidity from 5% to 95% (none condensing)
Water resistance Not waterproof
Memory
Parameter Value
Built-in No
SD card No
Energy supply
Parameter Value
Battery Li-ion polimer 3.7V 4500mAh
Input charge 5V/2A via USB
Output charge 5V/2A via USB
Operating time
Parameter Value
Standby time 30 days (90 days without GSM network
connection)
Network
Parameter Value
GNSS GPS / LBS
Type of data traffic GSM / GPRS (2G)
SIM card Micro
GSM frequencies 850, 900, 1800 és 1900 MHz
GSM chip MTK
GPS chip MTK
GPS sensitivity -159 dbm
GPS accuracy 10-15 m
Communication
Parameter Value
SMS Yes
TCP Yes
Sensors
Parameter Value
Vibration detection Yes
Magnetic detection Yes
Voice detection Yes
Flexcom
Flexcom Communication Ltd Installation and operating instructions (2021/03/24)
8/25
Interface
Parameter Value
GSM antenna Belső
GPS antenna Internal
Built-in microphone Yes
Built-in speaker Yes
Built-in lamp Yes
Flexcom
Flexcom Communication Ltd Installation and operating instructions (2021/03/24)
9/25
User's guide
Transport and storage
The packaging is designed to protect the product from the usual physical effects during transport. Be
careful to avoid effects other than these.
The packaging of the product is not water, flame and heat resistant and only moderately pressure
resistant. Therefore, do not store the package in a humid environment, within the scope of heat-
emitting equipment, or place heavy objects on it.
Commissioning
The package consists of a box containing the device and its accessories.
Unpacking
Open the box.1.
Remove the product.2.
Remove the retaining insert to protect the device.3.
Remove the accessories.4.
Contents of the package
1 tracking
device 1 wall mount 1 USB charging
cable 1 magnet 1 velcro 1 installation
instructions
Flexcom
Flexcom Communication Ltd Installation and operating instructions (2021/03/24)
10/25
Preparing the SIM card
As with mobile phones, a SIM card is required to operate the device. The device communicates with
the mobile service provider's network via SIM card, SMS or mobile phone or PC applications.
You can purchase the card independently from your mobile service provider or, in the
case of a software subscription, from your product distributor. If you received the SIM
card from your dealer, you do not need to make any settings: the card is already set up,
inserted in the device, switched on and ready for use.
If you have received the SIM card from your dealer, do not try to transfer it to another
device (eg phone) and use it! The distributor (service provider) will reimburse the
resulting costs or the correction of the resulting errors.
Settings for your SIM card
If you did not obtain the SIM card from your tracking device vendor, you must set it up before
inserting and using it in the device, which you can do as follows.
Disable SIM card PIN and other functions
Insert the SIM card in your phone.1.
Among the setting functions of the phone2.
turn off the PIN code request, auto-reply and call forwarding options.3.
After turning off the above, insert the card into the tracking device. See the next section for
instructions on how to insert the SIM card.
Setting up data traffic
If you want to operate the device not only via SMS, but also e.g. If you use the software tracking
service provided by your dealer, you must activate GPRS (Internet) data traffic and use the
appropriate network settings if you use your own SIM card. To do this, you must send SMS messages
from your phone to the phone number of the SIM card inserted in the tracking device, as shown in the
table below.
Before sending the instructions in the table below from your phone to the phone number
of the device's SIM card, set the administrator's phone number on the device in a
preliminary SMS.
Send an SMS from your phone to the phone number of the device with the following
content: password,sos1,phone-number#
Example: 123456,sos1,06209876543
All other commands sent via SMS will only be received and executed. Always use
Flexcom
Indice
Altri manuali Flexcom GPS
Flexcom
Flexcom ICAR IK121 Manuale utente
Flexcom
Flexcom TK108A Manuale utente
Flexcom
Flexcom TKSTAR TK906 Manuale utente
Flexcom
Flexcom TKSTAR TK905 Manuale utente
Flexcom
Flexcom ICAR IK122 Manuale utente
Flexcom
Flexcom TK303 Manuale utente
Flexcom
Flexcom ICAR IK205 Manuale utente
Flexcom
Flexcom TKSTAR TK806 Manuale utente
Flexcom
Flexcom TK306-3G Manuale utente
Flexcom
Flexcom TKSTAR TK905B Manuale utente
