for Li-ion battery
[NOTE]
When charging a cool battery pack
(below 0oC (32oF) in a warm place,
leave the battery pack at the place
and wait for more than one hour to
warm up the battery to the level of
the ambient temperature. Otherwise
battery pack may not be fully
charged.
Cool down the charger when
charging more than two battery
packs consecutively.
Do not insert your fingers/ nails into
contact hole, when holding charger or
any other occasions.
1. Place charger in a relatively cool and
well-ventilated area.
2. Plug charger into the AC outlet.
CAUTION: Ensure that the power
source to be utilized conforms to the
power requirement specified on the
product nameplate.
3. Turn the battery up-side-down and
slide the battery into charger while
keeping the alignment marks line up.
Slide the forward in the direction of
the arrow. Do not force battery as it
should slide easily into place with
nominal force. Any difficulty doing so
would indicate an incorrect
alignment.
4. If the power lamp (red) does not
light immediately or goes out soon
after the charger is plugged in,
consult an authorized service
center.
5. During charging, the charging lamp
(green) will start flashing. When
charging is completed, an internal
electronic switch will automatically
be triggered to prevent
overcharging.
- Charging will not start if the battery
pack is warm. For example,
immediately after heavy-duty
operation. The yellow standby
lamp will be flashing until the
battery cools down.
6. If the temperature of the battery
pack is 0oC or less, charging takes
longer to fully charge the battery
pack than the standard charging
time. Even when the battery is fully
charged, it will have approximately
50% of the power of a fully charged
battery at normal operation
temperature.
7. Once the battery is fully charged,
the green lamp will be lit to indicate
the gone into a trickle charge
mode.
Li-ion Battery Pack
[NOTE]
Your battery pack is not fully charged
at the time of purchase. Be sure to
charge the battery before first use.
