Flexvision Dvdvcp01 Manuale utente

SERVICE MANUAL

MOBILE DVD-VIDEO PLAYER

DVDVCP01

CAUTION

BEFORE SERVICING THE CHASSIS, READ THE "SAFETY

PRECAUTIONS", IN THIS MANUAL.

• Safety Check after Servicing

Examine the area surrounding the repaired location for damage or deterioration. Observe that screws, parts and wires

have been returned to original positions. Afterwards, perform the following tests and confirm the specified values in

order to verify compliance with safety standards.

1. Insulation resistance test

Confirm the specified insulation resistance or greater between power cord plug prongs and externally exposed parts

of the set (RF terminals, antenna terminals, video and audio input and output terminals, microphone jacks, earphone

jacks, etc.). See table below.

2. Dielectric strength test

Confirm specified dielectric strength or greater between power cord plug prongs and exposed accessible parts of the

set (RF terminals, antenna terminals, video and audio input and output terminals, microphone jacks, earphone jacks,

etc.) See table below.

3. Clearance distance

When replacing primary circuit components, confirm

specified clearance distance (d), (d') between soldered

terminals, and between terminals and surrounding

metalic parts. See table below.

Table 1: Rating for selected areas

* Class II model only.

Note: This table is unofficial and for reference only. Be sure to confirm the precise values for your particular country

and locality.

4. Leakage current test

Confirm specified or lower leakage current between B (earth ground, power cord plug prongs) and externally

exposed accessible parts (RF terminals, antenna terminals, video and audio input and output terminals, microphone

jacks, earphone jacks, etc.)

Measuring Method: (Power ON)

Insert load Z between B (earth ground, power cord plug

prongs) and exposed accessible parts. Use and AC

voltmeter to measure across both terminals of load Z.

See figure and following table.

Table 2: Leakage current ratings for selected areas

Note: This table unofficial and for reference only. Be sure to confirm the precise values for your particular country and

locality.

Exposed

accessible

part AC Voltmeter

(high impedance)

Earth Ground

power cord plug prongsB

Fig. 2

AC Line Voltage Region Insulation Dielectric Clearance

Resistance Strength Distance (d), (d')

100V Japan ≥1 MΩ/500 V DC 1kV 1 minute ≥3 mm

110 to 130V USA & – – – 900V 1 minute ≥3.2mm

Canada

* 110 to 130 V Europe ≥10 MΩ/500 V DC 4 kV 1 minute ≥6 mm (d)

200 to 240 V Australia ≥8 mm (d')

(a: Power cord)

Fig. 1

Primary circuit terminals

Chassis

AC Line Voltage Region Earth Ground

Load Z Leakage Current (i) (B) to:

100V Japan ¡ ≤1m A rms Exposed accessible

parts

110 to 130 V USA & ¡ ≤0.5 m A rms Exposed accessible

Canada parts

¡ ≤0.7 m A peak Antenna earth

110 to 130 V Europe ¡ ≤2 m A dc terminals

200 to 240 V Australia ¡ ≤0.7 m A peak Other terminals

¡ ≤2 m A dc

1.5k

1.5kµF

50k

TOTAL CONTENTS

SECTION 1. GENERAL....................................................................................................................2

SECTION 2. CABINET & MAIN FRAME.........................................................................................6

SECTION 3. ELECTRICAL ............................................................................................................10

SECTION 1. GENERAL

CONTENTS

1-1. SPECIFICATIONS............................................................................................................................3

1-2. IDENTIFICATION AND OPERATION OF CONTROLS...............................................................4

* Design and specifications subject to change without notice.

1-1. SPECIFICATIONS

Power DC 12V Negative Ground

Consumed electricity 24W (supplementary 2.5W)

Weight 5.3kg

Dimension (WxHxD) 250mm x 135mm x 266.5mm

Operative temperature 0°C ~ 45°C

Installation condition Horizontal / Relative humidity under 80%

Signal type NTSC COLOR

VIDEO input 1.0Vp-p unbalanced, RCA JACK

AUDIO input -8.8dBm, RCA JACK

VIDEO output VIDEO output terminal, 1.0Vp-p unbalanced, RCA JACK

AUDIO output Audio output terminal (2 kinds): -7.8dBm(VCP), 2.0Vrms(DVD), RCA JACK

Playable tape Very high density tapes with VHS marks

Playable disc DVD, VIDEO-CD, CD (12mm), CD (8mm), MP3, CD-R, CD-RW, DVD-RW, DVD+RW

Tape speed SP: 33.35mm/s, SLP: 11.12mm/s

Playtime SP: 2hrs, SLP: 6hrs (use of T-120 tape)

VIDEO S/N (VCP) Over 43dB (Standard recording)

Resolution VCP Over 220 lines (Standard recording)

DVD Over 500 lines (DVD Disc PLAY)

AUDIO (VCP) Over 40dB

AUDIO (DVD) 80dB

AUDIO dynamic range 90dB

1-2. IDENTIFICATION AND OPERATION OF CONTROLS

& 1 42 3*

“ ‘ + = Q q W w

( )

!DVD indicator

Lightgreen whentheDVD modeis correctly selected

@DISC IN indicator

#SOURCE

Useto changeDVDmode toVCPand viceversa.

$Place to insert disc

%DVD insertion indicator

^DISC EJECT

Whenpressed duringplaymode, thetape is stopped. Whenpressed during

stopmode, thetapeis ejected.

&MENU

Usedto displaythecontents menuof the loadedDVD disc.Thisfunction isdisc

dependent.A DVDdiscmay notcontain a contentsmenu.

*Cursor LEFT

Usedto movetothe desiredmenu. Also canbe usedtodisplay function.

(Cursor RIGHT

Usedto movetothe desiredmenu. Also canbe usedtodisplay function.

)ENTER

1Cursor DOWN

Usedto movetothe desiredmenu. Also canbe usedtodisplay function.

2Cursor UP

Usedto movetothe desiredmenu. Also canbe usedtodisplay function.

3PREVIOUS

Usedto movetothe previouschapter (DVD)or track(VCD orCDDA)fromthe

currentchapter ortrack.Pressingthis buttonshows previous playlist when

playingVCD withPBC.

4 NEXT

InDVD, usedtomove tothe next chapter(DVD)or track(VCDor CDDA)fromthe

currentchapter ortrack.Pressing thisbutton shows nextplay listwhenplaying

VCDwith PBC.InVCP,used towatch a seriesof screensoneby one(Frame

Advance).

5 Remote control receiver

6VCP indicator

Lightgreen whentheVCP modeis correctly selected

7Cassette IN/Auto REPEAT indicator

CassetteIN -Lightsgreenwhen thecassette is inserted.Auto REPEAT-The

VCPcycles throughthefollowing modeand the indicatorlights orange.The

tapewill playtothe end,rewindto the beginningand playagain.When this

functionis enabled,allcontrol functionsare disabled.

8DEW/Hi-Fi indicator

Whenpower ison,thisindicator flashesred to indicateexcessive moisture

buildupinside theVCP.The unitwill not operateuntil itdriesout sufficiently

(thetape canbeejected fromthe unit). WhenDEW modehasbeen

activated,leavethe unitonto allowit to dryout completely.Whendetected Hi-

Fiaudio modeinthe playbackmode, this indicatorflashes green.

9Place to insert video tape.

0Tape Insertion indicator

“POWER/STANDBY

Activatesthe unitPOWERON orSTANDBY.

‘STOP

Tostop thecurrentplaying mode,pressSTOP. WhenusingVIDEO CD2.0,CVD

andSVCD withPBCfunction included,thisbutton worksasa RETURNbutton.

Tostop PBC,disc,use PBCbutton.

+REW

Toplay adiscor tapefastreverse.While Paused,thisbuttonwill palyslow

reverse.(DVDonly)

=PLAY/PAUSE

Usethis buttontoplay orpause the disc(or tape).Pressingthisbutton during

play,causesthe disc(ortape)to pauseif in pausemode itfunctionsas thePLAY

button.

QFF

Toplay adiscor tapefastforward.While Paused,thisbuttonwill playslow

forward.

qTRACKING -/+

Useto adjustthedisplay suitablefor warching.

WAV.SW

AV.SWis usedtodisplay eachoutput screen onthe TVmonitorby matching

eachscreen withoutputsource.

EJECT

Toeject adiscor tape,pressEJECT button.

AV JACK

Connectthese jackstothe audio/videoout jacks terminalof yourGame

machineor Camcorderusingthe RCAcord provided.

@# $ %

NOTE: This VCP is for 12Vdc use only; DO NOT use in 24Vdc vehicles. If you use this unit in a 24Vdc vehicle, all the

indicator lamps will blink indicating a major malfunction. Disconnect the plug from the power source

immediately.

!Infrared(IR)INPUTConnector

ThisconnectorprovidesatwowireinterfacewithvariousFlexvisionvideomonitor

products.

*Connectordescription

@Infrared(IR)INPUTConnector(RemoteEye)

Thisconnectorprovidesathree-wireinterfacewithreceiveraccessory.(RemoteEye).

(P/N136-2070)

#AUDIO/VIDEOINConnector

TheseconnectorsprovideaninterfacetotheAUDIO/VIDEOOUTconnectorsofyour

GamemachineorCamcorderusinganRCAcord.

$DC12VJack

WhenusingaDCpowersource,connectthisjackto12VDC.

*Connectordescription

%AUDIO/VIDEOOUTConnectors

TheseconnectorsprovideaninterfacetotheAUDIO/VIDEOINconnectorsofyour

videomonitor,usinganRCAcord.

SECTION 2. CABINET & MAIN FRAME

CONTENTS

2-1. EXPLODED VIEW............................................................................................................................7

1) MAIN CHASSIS

2) PANEL FRONT

2-2. PACKING ASSEMBLY....................................................................................................................9

2-1. EXPLODED VIEW

1) MAIN CHASSIS ASS'Y

2) PANEL FRONT ASS'Y

Altri manuali per dvdvcp01

Indice

Altri manuali flexvision Lettore DVD

flexvision

flexvision dvdvcp01 Manuale utente

Manuali Lettore DVD popolari di altre marche

Sony

Sony DVP-F11 Manuale utente

Philips

Philips DVP3560K/F8 Manuale utente

LENCO

LENCO DVP-740 X2 Manuale utente

JVC

JVC XV-N650BEU Manuale utente

Aiwa

Aiwa XD-DV370 Manuale utente

MedeaWiz

MedeaWiz Sprite 4K DV-S4 Manuale utente

Denon

Denon DVM-1805 - DVD Changer Manuale utente

Toshiba

Toshiba SD-3815 Manuale utente

Tevion

Tevion 44330 Manuale utente

Samsung

Samsung DVD-HD860 Manuale utente

Sylvania

Sylvania DP170SL8 Manuale utente

Toshiba

Toshiba SD-P1200 Manuale utente

JVC

JVC XV-D9000E Manuale utente

Dolby Laboratories

Dolby Laboratories CP650 Manuale utente

Philips

Philips DVD737K/931 Manuale utente

Denon

Denon DVD-5900 Manuale utente

Philips

Philips DVD 951 Manuale utente

Philips

Philips DVDR3460 Manuale utente