FD932DVD-4B! ! !
5!!
Revision!K,!January!2009!
Operation Instructions
To power the unit up, press the power button. The unit will light up and
display a Flight Display Systems logo on the display(s). Insert a CD or DVD
into the slot, with label side up (away from the controls, if mounted vertically).
The CD or DVD will load and automatically begin to play. Use the volume
buttons, located on the left side of the unit, to adjust the volume to your
preferred level. The FD932DVD-4B will remember its volume setting when
powered down.
Note: CDs and DVDs are recorded at different levels, so it is normal for
DVDs to be quieter than CDs at the same volume setting.
External Inputs
In order to use the inputs on the front of the unit, use the Mode button on the
front panel or remote to select [Line] on the display. The external input will
only output to composite, not S-Video.
Sleep Mode
By default, the FD932DVD-4B is programmed to go into a Screen Saver
mode after a period of inactivity. If the unit is left inactive for 30 minutes, the
FD932DVD-4B will go into “Sleep Mode” which can be identified by a lack of
LED display (the buttons will still be lit. To exit Sleep Mode, simply power
down and re-apply power to the unit.
Note: During Sleep Mode, discs cannot be inserted.
To disable the Screen Saver and Sleep Mode:
1. On the remote, press SETUP.
2. On the General Setup Page, press the DOWN ARROW to highlight
Screen Saver.
3. Press the RIGHT ARROW to highlight On and then use the DOWN
ARROW to switch to Off.
4. Press ENTER to save the selection, and then SETUP to exit the
menu.
