Switching the machine On / Off
Switching the machine on
1Always turn on the vacuum before turning on the machine.
2Pull out the red emergency button.
3Press the green button on top of the machine.
4The machine is starting up. Please, wait a moment to let the
machine completely start.
5Adjust the sawing-blade to the required depth.
6Start grinding the floor.
Switching the machine off
1Remove the sawing-blade from the surface and switch the switch
to “off”.
2Press the red button on top of the machine.
3The machine will turn itself off. After the machine is turned off,
turn off the vacuum. In case that the white light stays on (only at
the 400V edition) an error has been detected. This will prevent
the grinding engine from starting. To solve this error, the phase
needs to be changed. Before changing, ensure that there is no
power on the machine anymore.
Driving system
Place both hands on the handles to drive straight. When only placing a hand on the
left handle, the machine will turn right. When only placing a hand on the right
handle, the machine will turn left. The driving speed will be determined by the
meter on top of the electrical box. The driving speed will be influenced by the
hardness / resistance of the floor. For the 230V version the maximum is 14
Amp
è
re, for the 400V version the maximum is 9 Amp
è
re.
Warning: It is strictly forbidden blocking one or both handles. This will prevent the
machine from automatically stopping if the handles are being released.
6. Maintenance
Regularly check the condition of the sawing-blade. Directly replace the sawing-
blade when its damaged, distorted, or outworn.
Prevent premature wear by keeping the machine dust free. Regularly clean the
machine with a vacuum.
Repairs may only be conducted by suppliers or certified workers. If the repair
has not been done by Flooriq, warranty on the machine will be voided. Keep
your machine safe and reliable.
