6
Turn on the remote control. To activate the remote control,slowly push
up the throttle stick to the top and then push it down to the bottom. The
remote control is activated once you hear a beep.Then, the
indicator light will flash rapidly whilst the remote control is sending out
a connection signal.
Connect the battery plug to the helicopter battery cable,the indicator light
of the helicopter will flash slowly,set the helicopter down on a flat stable
platform. Once the helicoter receives the connection signal,the indicator
light on the helicopter will flash rapidly.
Preparation for flight
When the whole auto signal connection process is finished,both
indicator lights on the helicopter and transmitter will be steady “ON”,
then push up the throttle stick slowly and the helicopter will take off.
1.User may push either of the control sticks to skip the auto signal connection.
2.Follow the connection tips precisely.
3.Once the transmitter is turned off, the connection procedure must be repeated
to operate the helicopter.
4.Please pull out the battery plug from the helicopter battery socket when you
have finished flying the helicopter.
OPERATIONAL TIPS
Check and regulate the swashplate of the helicopter
The swashplate of the helicopter should be kept horizontal, otherwise, the helicopter will fly
forwards/backwards/left/right on its own without any control signal.
Therefore it is very important to check and confirm that the swashplate is horizontal before
flying the helicopter. There are two ways to make the swashplate horizontal.
This product comes with a battery, please pay attention to the following safety instructions:
Only use the charger provided to charge the battery.
When charging the battery: If the battery becomes too hot, then the battery is overcharged. If this is the case then stop charging
the battery. As over charging will damage the battery.
Always supervise the charging of the battery.
Do not take the battery apart.
After flying the model the battery will be hot.
Wait for about 30 minutes for the battery to cool
down before recharging.
If you are planning on leaving the model for sometime and not
using it. Then charge it for about 1 hour before storing it away.
