FOCO Standard container Manuale utente
ASSEMBLY INSTRUCTIONS
Standard container
Equipment
- Screwdriver or drill (Phillips head)
- 13 mm wrench
- 19 mm wrench
- Torque wrench (13 mm and 19 mm inserts)
Manual:
First, using the 19 mm and 13 mm wrenches, remove the screws that hold the floor and roof package to-
gether, save these screws. Also unscrew and save the lifting eyes on the roof.
Then remove the wooden blocks at the corners of the package and the iron blocks in the middle, these
are not required for assembly, but may be useful in leveling the container.
info@fococontainers.com www.fococontainers.com0031 85 0685 590
Then the panels are removed from the package, do not place them on the asphalt this can cause dama-
ge in the form of dents or scratches. Protect the panels with leftover wood or plastic from the package.
Always mount a container on a straight level surface.
Next, the panels are placed in the correct position (photo above). They are mounted using the 13 mm and
19 mm screws from the package with a corresponding washer in between (photos below). During assem-
bly, the panels should be held by an extra person to keep them from falling to the floor. Once the panel is
attached to the floor it can be released unless there is wind. The side panels (walls) are placed first, then
the door is placed.
info@fococontainers.com www.fococontainers.com0031 85 0685 590
Then the two panels are mounted using a 13mm screw, a nut and two washers. The screw is fixed with the
nut in the holes with a washer on both sides for protection.
Each corner of a container contains three fixing holes where a screw must be placed.
1. 2. 3.
4. 5. 6.
Using the key, the cylinder lock is attached (photo 1). Then the door handle is attached (photo 2) and
must be screwed on both sides using 3 screws (photo 3 + 4). Then the lock is fixed with the long screw on
the side of the door (photo 5). Finally, the metal protection parts are placed on each latch and on each
keyhole (photo 6).
info@fococontainers.com www.fococontainers.com0031 85 0685 590
The roof must be placed with (at least) two people, for larger models more people are required. As seen
in the pictures above, the roof is slid onto the sliding rails at the top of the container. The roof is correctly
placed when it falls into the slots. To check if the roof is positioned correctly, look from inside the contai-
ner.
Then the roof is mounted using a 13 mm screw, and nut and two washers, as shown in the picture above.
Finally, the crane eyes are reattached to the roof of the container, no tools are required for this.
info@fococontainers.com www.fococontainers.com0031 85 0685 590
Indice
Altri manuali FOCO Deposito all'aperto
