Instruction manualHT250 www.foehrenbach.be
Date: August 2007 Documentrev. : 6Page : 4/ 11
3. ADJUSTMENTS
Adjustmentsofcrimpheight:
Eventually, thetoolhingescanwear,sothat the crimpheightmustbereadjusted(see
belowspecifiedheight).
Thisisdonebylooseningthescrew(item21,figure1)androtatingthestoprings
(item20 , figure1)onestoptochange thecrimpheight approximately0.05mm (0.002
inches).
Adjustmentoffeedtrack unit (seefigure2)
CAUTION:Noadjustmentsshouldbemadewithscrew(item21,fig1),nut(item22,
fig1)andwithscrew(item23,fig1).
Adjustmentoffeeding:
Loosenscrews(item13,fig2)and turnscrew(item27,fig2)tothe left forfurther
feedingofterminaland tothe rightforlessfeeding.The fed terminalmustlayabove
theanvil.Tightenscrew(item13,fig2)afteradjustment.
Adjustmentofcutterplate:
Loosenscrews(item18,fig2)andplacecutterplate(item19,fig2)againstthe anvil.
Tightenscrews(item18, fig2)afteradjustment.
Note:1)Duringadjustmenthandtoolmustbeinclosedposition.
2)When closinghandtool(withoutterminal),thecutterplatemaynotmoveup.
Adjustmentofterminalposition:
Loosenscrews(item18, fig2)andadjustterminalpositioner(item17,fig2)sothatthe
feed fingerlocatestheterminalsthroughthepilotholes.Tighten screws(item18, fig2)
afteradjustment.
Note: 1)The terminalpositionermaynotdamage theinsulation barrelorwirebarrel
ofterminal.
2)Thisadjustmentmayaffectthebellmouthoftheterminal.
