FoMaKo K820N Manuale utente

FoMaKo
4K NDI/SDI/HDMI/USB
PTZ STREAM CAMERA
(User Manual V1.0)
Please Note: Only NDI version cameras have NDI function, other version cameras don’t have NDI function.
FoMaKo
E-Mail: ivan@fomako.net
Website: www.fomako.net
Phone: 0086-18565635753
Address: 10F NiuLanQian Building, Minzhi, Longhua,
Shenzhen, China, 518000
Please feel free to contact us if you have any questions.

Copyright
All contents of this manual, whose copyright belongs to our corporation, cannot be cloned, copied or
translated without the permission of our corporation.
Notice
Product specifications and information which were referred to in this document are for reference only.
We may change, delete, or update any content at any time and without prior notice.
FCC NOTICE (Class A)
This product complies with Part 15 of the FCC Rules. The operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
This product has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/television technician for help.
Class A ITE
Class A ITE is a category of all other ITE which satisfies the class A ITE limits but not the class B ITE limits.
Such equipment should not be restricted in its sale but the following warning shall be included in the
instructions for use:
Operating this equipment in a residential environment may cause radio interference.
European Community Compliance Statement (Class A)
This product is herewith confirmed to comply with the requirements set out in the
Council Directives on the Approximation of the laws of the Member States relating to
Electromagnetic Compatibility Directive 2014/30/EU.
No
t
e
Warning

Quick Start
Add Cameras to Your Network
Please do the connections as the following. You must have a router in your network, then router will
assign IP address for the cameras automatic. If you don’t have router in your network, cameras can’t get
IP address from your network.
Camera’s screen will show its IP address, you can visit camera’s webpage by camera’s IP address.
Tips: When you login the camera’s webpage, you’d better change the IP from “Dynamic IP Address” to
“Fixed IP Address”, then camera will keep currently IP ,or when camera rebooted, router rebooted,
router will assign a new IP address for the camera.
Visit Camera’s Webpage
Please use web browser such as: Google Chrome, Firefox or Safari to Visit camera’s IP address
User name: admin Password: admin
IP Streaming to Vmix or OBS
Tips: recommend to use VLC streaming in Vmix and OBS, it has lower latency.

If you want to use normal RTSP stream:
RTSP UDP Stream URL: rtsp://192.168.0.100:554/1
Please note, you need change the IP address to your camera’s IP address.
IP Steam to YouTube or Facebook
YouTube, Facebook or other live broadcast platforms will supply Stream URL(server URL) and stream key
for you.
Example for YouTube:
Stream URL: rtmp://a.rtmp.youtube.com/live2/
Stream Key: 8m8q-0yrp-w95f-spd0-ft55
Now go to camera’s webpage -> network -> RTMP Settings.
input the RTMP stream URL:
rtmp://a.rtmp.youtube.com/live2/8m8q-0yrp-w95f-spd0-ft55
(Format: Stream URL/Stream Key)
Save and reboot the camera, camera will stream to YouTube.

Example for Facebook:
Server URL: rtmps://live-api-s.facebook.com:443/rtmp/
Stream Key: FB-117626344422167-0-AbzhIyyXbQGNT47w
Now go to camera’s webpage -> network -> RTMP Settings.
input the RTMP stream URL:
rtmps://live-api-s.facebook.com:443/rtmp/FB-117626344422167-0-AbzhIyyXbQGNT47w
(Format: Stream URL/Stream Key)
Save and reboot the camera, it will stream to Facebook.

Connect Camera to Controller Keyboard
Some information you need:
User Name: admin Password: admin
Sony Visca port: 52381 IP Visca UDP port: 1259
IP Visca TCP port: 5678 Onvif Port: 2000
We recommend to use Sony Visca or IP Visca control protocols, the two protocols are more steady and
work better.
Let’s use FoMaKo KC-608 IP controller for example:
(1) Connection: Camera and the IP controller must be in the same LAN (connect to the same
router/switch by network cable)
(2) Enable controller’s DHCP, then reboot the controller
Then, router will assign an IP address for the controller
(3) press “Setup” - >Add: Sony Visca (or IP Visca) - > input your camera’s IP - > input port:52381 (IP Visca
UDP:1259) - > input camera control ID(1-255 numbers)
(4) If you have more than one cameras need to add to the controller, please press “IP” button to add the
camera’s IP address to controller one by one.
How to output 4K video
Camera’s video resolution:
SDI output: max 1080P@60fps
HDMI output: max 4K(3840x2160)@60fps
IP(NDI)Output: max 4K(3840x2160)@60fps
USB Output: 4K(3840x2160)@30fps
So, if you want to output 4K video, please use HDMI, IP, NDI or USB video out,
SDI video out max support 1080P.
Important:
- HDMI and IP(NDI) output max support 4K@25/30fps at the same time;
- If HDMI output set to 4K@50/60fps, then, IP(NDI) max support 1080P@60fps;
- If IP(NDI) output set to 4K@50/60fps, then, HDMI max support 1080P@60fps.

Simultaneous output three HD digital signals
(1) HDMI + USB + IP(NDI)
(2) 3G-SDI + USB + IP(NDI)
Note: HDMI and 3G-SDI can’t output at the same time.
If you need more supports, please contact us at: [email protected], normally, we can reply you within 12
hours.
FoMaKo Supports Team

AI Tracking Guide
1. Turn on tracking
1.1 Single scenario
Press the F3 on the remote control to start a trace .
When there is only one person in the scenario, press the F3 key (Figure I) on the remote control to start a
trace, the camera will lock the target for tracking directly.
The screen is shown as the following figure, the tracking program starts successfully.(Figure II)
When the camera finds that the target is lost, it will stand still at the position where the target is lost for a
few seconds and then return to the home position. It will automatically enter the tracking state until the
target appears again
1.2 Multiplayer scenario
Press the F3 on the remote control to start a trace .
If there are multiple people in the scenario, press the F3 key (Figure I)on the remote control to start a
trace, a green wireframe will appear on the screen(Figure III)to indicate the tracking target. Select the
object to be tracked and press the home key to start tracking. Then the green wireframe disappears, and
the screen is shown as the following figure, the tracking program starts successfully.(Figure IV) .
If change a target is needed during Multi people tracking process, Press the left and right buttons on the
remote control is help.
Figure I Figure II

When the camera finds that the target is lost, it will stand still at the position where the target is lost for a
few seconds and then return to the home position. It will automatically enter the tracking state until the
target appears again
2. Turn off tracking
In the tracking state, press the F4 to exit tracking mode.
When you are willing to end the tracking, press the F4 key (Figure V) on the remote control to
exit tracking mode. After tracking, the camera will return to home position, the screen is
shown as the following figure, the tracking program exits successfully. (Figure VI)
Figure III
Figure IV
Figure V
Figure VI

FoMaKo FocusYourStreaming www.fomako.net
User Manual Catalogue
1Safety Precautions..................................................................................................................... 1
2Packing List ................................................................................................................................1
3Quick Start..................................................................................................................................1
4About Product............................................................................................................................ 2
4.1 Feature.......................................................................................................................................................2
4.2 Specification..............................................................................................................................................2
4.3 Interface and Switch .................................................................................................................................4
4.4 Dimension..................................................................................................................................................4
4.5 Installation ................................................................................................................................................5
4.6 Remote Control.........................................................................................................................................6
5GUI Settings................................................................................................................................7
5.1 MENU .........................................................................................................................................................7
5.2 EXPOSURE .................................................................................................................................................7
5.3 COLOR........................................................................................................................................................7
5.4 IMAGE.........................................................................................................................................................8
5.5 P/T/Z ..........................................................................................................................................................8
5.6 NOISE REDUCTION ....................................................................................................................................8
5.7 SETUP ........................................................................................................................................................8
5.8 COMMUNICATION SETUP..........................................................................................................................9
5.9 RESTORE DEFAULT....................................................................................................................................9
6WEB Settings ..............................................................................................................................9
6.1 Access Camera ..........................................................................................................................................9
6.2 Control Camera .........................................................................................................................................9
6.3 Video Settings..........................................................................................................................................10
6.4 Image Settings.........................................................................................................................................11
6.5 Audio Settings .........................................................................................................................................12
6.6 System Settings.......................................................................................................................................12
6.7 Network Settings.....................................................................................................................................12
6.8 Device Information .................................................................................................................................14
6.9 Download Upgrade Program .................................................................................................................14
7Troubleshooting ......................................................................................................................14
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali FoMaKo Telecamera di sicurezza

















