8
QUICK REFERENCE SHEET
Failure codes:
Display shows: F 01
Indicates: An internal fault in the control.
Correction: Touch the Stop/Clear pad. If the dis-
play continues to display F 01 or if the
code returns when the dryer is re-
started,replace thecontrol.
Display shows: F 02
Indicates: Control temperature sensor open or
shorted.
Correction: Removed the wires from the control
temperature sensor and measure the
resistance of the sensor. If the meter
does not read 50,000 Ohms +/- 10%
replacethesensor.Ifthemeterreading
is within 10% of 50,000 Ohms, check
the wiring between the electronic con-
trol board and the sensor. If the wiring
is good, replace the electronic control
board.
Display shows: F 03
Indicates: Noheat
Correction: Touch the Stop/Clear pad to clear the
F 03. Program the dry for a NORMAL
CYCLE with HIGH HEAT and touch
START. Measure the voltage drop
across the terminals of relay RL 2 on
theelectroniccontrolboard. Ifthemeter
reads 240 VAC on electric models or
120 VAC on gas models, replace the
electronic control board. If the meter
readszero,removepowerfromthedryer
and disconnect the black wire electric
models and orange wire gas models
from the relay. Reconnect power and
measurethevoltagedropbetween red
wire on the relay RL 2 to neutral. If the
meterreadszero,thewirebetweenthe
incominglineand relay RL2is open. If
the meter reads 120 VAC, check the
rest of the heating circuit as described
in the trouble shooting section.
Display shows: F 04
Indicates: Thedryingtime has exceeded thepro-
gram time for that cycle.
Correction: TouchtheStop/Clear pad.Programthe
dry for a NORMAL CYCLE with HIGH
HEATandtouchSTART.Checkforany-
thing that would extend the dry time
such as:
1. Dryer not heating.
2. Restricted vent.
3. Blower fan blade broken or loose.
4. Dryer installed in a closet with a
soliddoor.
5. Badconnect in sensorbar circuitor
dirty sensor bars.
If the dryer operates normally but the
F04 codereturns, replacethe control.
Display shows: F 05
Indicates: A problem with the key pad.
Correction: Disconnectthekeypadribbon fromthe
control and reconnect the ribbon. Try
allkeypadswitches to seetheyallfunc-
tion correctly. If they do not, try clean-
ingtheendoftheribbonwitha soft cot-
ton cloth. Reinstall the ribbon and pro-
gram the dryer to operate. If the code,
reoccursreplace the touch pad.
Note: See control removal instruction on
how to disconnect ribbon.
On line test:
Tostartthetestprograms,removepowerfromthedryer.
Reconnect power to the dryer and within 10 seconds
pressand hold the tempand the stop padsfor at least 2
seconds, then release. The control is now in the test
function.
1. Afteractivation, the WRINGLERIDicon should be
on.
