Important Safety Instructions
This manual contains important instructions to follow during installation and
maintenance
of the Photovoltaic Grid-connected
Inverter(Microinverter).To reduce the risk of
electrical shock and ensure the
safe installation and operation of the Microinverter, the following symbols
appear throughout this document to indicate dangerous conditions
and important safety instructions.
Specifications subject to change without notice - please ensure you are using the
latest manual found at the manufacturer website.
WARNING: This indicates a situation where failure to follow instructions may
cause a
serious hardware failure or personnel danger if not applied
appropriately. Use extreme
caution when performing this task.
NOTE
: This indicates information that is important for optimized
microinverter
operation. Follow these instructions strictly.
SafetyInstructions
Only qualified professionals should install and/or replace the
Microinverters. Perform all electrical installations in accordance
with local electrical codes.
Before installing or using the Microinverter, please read all instructions and
cautionary markings in the technical documents and on the Microinverter
system and the
solar-
array.
Be aware that the body of the Microinverter is the heat sink and can reach a
temperature
of 80℃. To reduce risk of burns,do not touch the body of the
Microinverter.
DO NOT attempt to repair the Microinverter. If it fails, contact technical support
to obtain an
RMA
number and start the replacement process. Damaging or
opening the Microinverter will void the warranty.
Caution!
The external protective earthing conductor is connected to the inverter
protective
earthing terminal through AC connector.
When disconnecting, disconnect the AC by opening the branch circuit breaker
first
