Garage Tek GT2005E Manuale utente
INSTALLATION INSTRUCTIONS
GT2005E
HORIZONTAL BIKE RACK
CARTON CONTENTS
QUANTITY DESCRIPTION
1 RACK W/ SHELF
2 EXTENSIONS
2 HOLDERS
1 ACTIVITY RACK COVER
8 NUTS
8 SCREWS, 1/2” LG
4 SCREWS, 5/8” LG.
TOOLS REQUIRED - PHILLIPS SCREW DRIVER / PLIERS
PG 1 QUESTIONS ???? CALL 1-866 664 2724 REV 1, 7/11
HORIZONTAL BIKE RACK - INSTALLATION
STEP #1: CHECK PARTS RECEIVED.
STEP #2: INSTALL EXTENSIONS AND HOLDERS AS SHOWN. USE SCREWS 1/2 LG & NUTS.
SELECT THE POSITION OF THE HOLDERS BASED ON BIKE FRAME SIZE TO BE STORED.
THIS RACK “LOCKS” INTO THE SLATWALL SO IT WILL NOT BE PULLED AWAY FROM THE WALL WHEN A BIKE
IS REMOVED FROM THE RACK. THAT IS THE REASON FOR NOT TIGHTENING THE HOLDER SCREWS AND THE
EXTENSION SLIDE FREELY.
CHECK FOR THE CORRECT TIGHTNESS OF THE SCREWS / NUTS BY INSTALLING THE RACK ON THE PANEL
NOW BEFORE INSTALLING THE ACTIVITY RACK COVER. YOU HAVE THE CORRECT TIGHTNESS OF THE
SCREWS IF THE RACK EXTENSIONS CAN BE MOVED FROM SLAT-TO-SLAT IN A SNAPPING ACTION. YOU
HAVE THE SCREWS TOO LOOSE IF THE RACK EXTENSIONS ARE NOT SNUGLY SEATED IN THE SLATS.
SEE THE INSTALLATION STEPS ON THE NEXT PAGE.
PG 2 REV 1, 7/11
INSERT INTO PANEL RAISE LEFT ARM INTO SLOT RAISE RIGHT ARM
FIND SLOT SNAP INTO SLOT COMPLETE
PG 3 REV 1, 7/11
STEP #3: REMOVED FROM PANEL AFTER TESTING FOR CORRECT SCREW / NUT TIGHTNESS AND USE THE
QUANTITY 4, 5/8 LG SCREWS TO FASTEN COVER ONTO RACK.
COMPLETE – REINSTALL ON PANEL AND MOUNT BIKE.
PG 3 REV 1, 7/11
Altri manuali Garage Tek Rack e supporto
