General DataComm PacketMate 1000 Manuale utente
001
Version: 3077
Copyright 2007-2010 ImageStream Internet Solutions, Inc., All rights Reserved.
Table of Contents
Router Manuals/001............................................................................................................................................1
PacketMate 1000 Router...................................................................................................................................3
Preface.....................................................................................................................................................3
Copyright..........................................................................................................................................3
Trademarks.......................................................................................................................................3
Scope of this Manual........................................................................................................................3
Manual Organization........................................................................................................................3
Safety Information............................................................................................................................4
Service Support and Training...........................................................................................................5
Chapter 1: Introduction and Specifications.............................................................................................6
Overview..........................................................................................................................................6
Specifications...................................................................................................................................7
Chapter 2: Installation and Setup............................................................................................................8
Overview..........................................................................................................................................8
Unpacking Instructions.....................................................................................................................8
Installation Procedures.....................................................................................................................8
Router Connections........................................................................................................................10
Chapter 3: Operations Information.......................................................................................................11
Open the Chassis:...........................................................................................................................11
CPU Location.................................................................................................................................12
Flash Storage Location...................................................................................................................13
Software..........................................................................................................................................14
Copyright..............................................................................................................................................14
Copyright..............................................................................................................................................14
Trademarks...........................................................................................................................................15
Related Publications.............................................................................................................................15
i
ii
Router Manuals/001
Router Manuals/001 1
001
2 Router Manuals/001
PacketMate 1000 Router
Preface
Copyright
©2011 General DataComm, Inc. ALL RIGHTS RESERVED. This publication and the software it describes
contain proprietary and confidential information. No part of this document may be copied, photocopied,
reproduced, translated or reduced to any electronic or machine-readable format without prior written
permission of General DataComm, Inc. The information in this document is subject to change without notice.
General DataComm assumes no responsibility for any damages arising from the use of this document,
including but not limited to, lost revenue, lost data, claims by third parties, or other damages. If you have
comments or suggestions concerning this manual, please contact: General DataComm, Inc.
Technical Publications Department
6 Rubber Avenue, Naugatuck, Connecticut USA 06770
Tel: 1 203-729-0271
Trademarks
All brand or product names are trademarks or registered trademarks of their respective companies or
organizations.
Scope of this Manual
This manual describes how to install and operate the PacketMate 1000 Router. The information contained in
this manual has been carefully checked and is believed to be entirely reliable. However, as General
DataComm improves the reliability, function, and design of their products, it is possible that information may
not be current. Contact General DataComm if you require updated information for this or other General
DataComm products.
General DataComm, Inc.
6 Rubber Avenue, Naugatuck, Connecticut 06770 U.S.A.
Tel: 1 203-729-0271 Toll Free: 1 800 523 1737
Manual Organization
This manual describes how to operate and configure your PacketMate 1000 Router system to meet various
operating requirements. It is divided into three chapters, with each chapter addressing the basic concept and
operation of this system.
Chapter 1: Introduction and Specifications. This section an overview of the PacketMate 1000 Route.
Chapter 2: Installation and Setup. This chapter unpacking instructions and installation procedures.
Chapter 3: Operation Information. This section provides illustrations and information on the system
architecture and how to optimize its performance.
PacketMate 1000 Router 3
Safety Information
This manual should be read in its entirety and all procedures completely understood before installing or
operating the unit. The notes that appear throughout this manual must be read prior to any installation or
operating procedure. Examples of notes used in this manual are shown below.
Note Indicates a note. It is something you should be particularly aware of; something not readily apparent.
A note is typically used as a suggestion.
Important Indicates an emphasized note. It is something you should be particularly aware of; something not
readily apparent. Important is typically used to prevent equipment damage.
The CAUTION, WARNING, and DANGER statements that appear throughout this manual are intended to
provide critical information for the safety of both the service engineer and operator. These statements also
enhance equipment reliability. The following definitions and symbols for CAUTION, WARNING, and
DANGER as they are used comply with ANSI Z535.2, American National Standard for Environmental and
Facility Safety Signs, and ANSI Z535.4, Product Safety Signs and Labels, issued by the American National
Standards Institute.
Safety Guidelines
Under proper conditions, this unit will operate reliably and safely in your network. If any component is
improperly handled or installed, equipment failure or personnel hazard may occur. Use caution and common
sense when installing network wires. Use the following guidelines, especially when unsafe conditions exist or
when potentially hazardous voltages are present:
001
4 Safety Information
Always use caution and common sense.• Repairs must be performed by qualified service personnel only.• To reduce the risk of electrical shock, do not operate equipment with the cover removed.• Never install network jacks in a wet location unless the jack is designed for that location.• Never touch uninsulated wires or terminals unless the line is disconnected at the network interface.• Never install network wiring during an electrical storm.•
Antistatic Precautions
Electrostatic discharge (ESD) results from the buildup of static electricity and can cause computer
components to fail. Electrostatic discharge occurs when a person whose body contains a static buildup touches
a computer component. This product may contain static-sensitive devices that are easily damaged. Proper
handling, grounding and precautionary ESD measures are essential when installing parts or cards. Keep parts
and cards in antistatic packaging when not in use or during transport. If possible, use antistatic floorpads and
workbench pads.
When handling components, always use an antistatic wrist strap connected to a grounded equipment frame or
chassis. If a wrist strap is not available, periodically touch an unpainted metal surface on the equipment.
Never use a conductive tool, like a screwdriver or a paper clip, to set switches.
Service Support and Training
General DataComm offers two comprehensive customer support organizations dedicated to pre-and post-sale
support services and training for GDC products. Corporate Client Services and Factory-Direct Support &
Repair assist customers throughout the world in the installation, management, maintenance and repair of GDC
equipment. Located at GDC?s corporate facility in Naugatuck,Connecticut USA, these customer support
organizations work to ensure that customers get maximum return on their investment through cost-effective
and timely product support.
Corporate Client Services
Corporate Client Services is a technical support and services group that is available to GDC customers
throughout the world for network service and support of their GDC products. Customers get the reliable
support and training required for installation, management and maintenance of GDC equipment in their global
data communication networks. Training courses are available at GDC corporate headquarters in Naugatuck,
Connecticut, as well as at customer sites.
Factory Direct Support & Repair
GDC provides regular and warranty repair services through Factory Direct Support & Repair at its U.S.
headquarters in Naugatuck, Connecticut. This customer support organization repairs and refurbishes GDC
products, backed by the same engineering, documentation and support staff used to build and test the original
product. Every product received for repair at Factory Direct Support & Repair is processed using the test
fixtures and procedures specifically designed to confirm the functionality of all features and configurations
available in the product.
As part of GDC?s Factory Direct program, all product repairs incorporate the most recent changes and
enhancements from GDC Engineering departments, assuring optimal performance when the customer puts the
001
Safety Information 5
product back into service. Only GDC?s Factory Direct Support & Repair can provide this added value.
Contact Information
Chapter 1: Introduction and Specifications
Overview
The PacketMate 1000 Router is a low-cost routers that provide a lightweight aluminum chassis, 266 MHz
CPU, 128 MB RAM, two on-board 10/100 ethernet ports, two Mini PCI slots, one USB bus with two internal
ports, flash storage, and no cooling fans. The chassis is designed for low-cost, small form-factor CPE
installations with operating temperatures from 0° to 55° C. The extended temperature version can be deployed
in outdoor enclosures with operating temperatures from ?10° to 65° C, and options for 24 VDC and ?48 VDC
power are also available.
The PacketMate is a set-top chassis that supports one DB-style and two RJ-style expansion ports. Expansion
options currently include network cards for 10/100 ethernet, T1/E1, and synchronous serial (RS232, RS422,
X.21 and V.35).
001
6 Service Support and Training
Indice
Altri manuali General DataComm Router di rete
Manuali Router di rete popolari di altre marche
NETGEAR
NETGEAR FS526T - Switch Manuale utente
Korenix
Korenix JetNet 5710G Series Manuale utente
Automated Logic
Automated Logic ZN551 Manuale del proprietario
Cisco
Cisco ASR 1000 Series Manuale dell'operatore
EnGenius
EnGenius ESR-9710 Manuale utente
Cisco
Cisco 805 Series Istruzioni operative e di sicurezza