Genesis GV70 Manuale utente

GENESIS

Electrified GV70

EMERGENCY RESCUE

MANUAL

1. Identification / recognition 1

2. Immobilization / stabilization / lifting 3

3. Disable direct hazards / safety regulations 5

4. Access to the occupants 9

5. Stored energy / liquid / gases / solids 12

6. In case of fire 15

7. In case of submersion 19

8. Towing / transportation / storage 20

9. Important additional information 23

Contents

Initial Response: Identify, Immobilize and Disable

The following procedures should be used whenever you are dealing with an

Electrified GV70 at an emergency scene. However, all operations should be

consistent with your department's standard operating procedures, guidelines, and

any applicable laws. When an EV is damaged in a crash, the high voltage safety

systems may have been compromised and present a potential high voltage

electrical shock hazard. Exercise caution and wear appropriate personal protective

equipment (PPE) safety gear, including high voltage safety gloves and boots.

Remove all metallic jewelry, including watches and rings.

1. Identification / recognition 1

Identify

The Electrified GV70 is an electric vehicle. Emergency responders should respond

to emergency scenarios involving the Electrified GV70 accordingly, exercising

extreme care and caution to avoid contact with the high voltage system within the

vehicle.

The safest method is to assume that Electrified GV70 you respond to is an electric

vehicle. Using the information provided in this section, responders will be able to

differentiate between the two.

1. Identification / recognition 2

General Vehicle Description

Identifying an Electrified GV70

Charge door

Charging port Charging port

(without cap)

GV70 GENESIS

The next step is to immobilize the vehicle to prevent any accidental movement that

can endanger the emergency response personnel and any crash victims. Since the

Electrified GV70 doesn’t have an engine, there will be instances where the vehicle

appears to be off because of the absence of engine noise. When in its “ready” mode,

the vehicle can move almost silently using the electric motor. Responders should

approach the vehicle from the sides and stay away from the front or rear as they are

both potential paths of travel. Instructions for immobilizing the vehicle are shown

below.

2. Immobilization / stabilization / lifting 3

Immobilize

* The actual image of vehicle may differ from the illustration

4. Chock the Wheels.

2. Engage Parking Brake

3. Press the START/STOP Button.

1. Push “P” button on the shift

selector.

2. Immobilization / stabilization / lifting 4

Extrication Operations

The extrication operations for the Electrified GV70 are similar to a conventional

vehicle. However, first responders should pay special attention when they extract

occupants in the vehicle. Before extrication operations, the first responders should

carry out “Initial Response: Identify, Immobilize and Disable” procedure section in

page 5 to 8.

Vehicle Stabilization

Use standard stabilization (cribbing) points, as shown. Always be sure to connect

to a structural member of the vehicle and avoid placing cribbing under high

voltage cables, fuel lines and other areas not normally considered acceptable.

* The actual image of vehicle may differ from the illustration

The final step in the initial response process, conducted after immobilizing the

vehicle, is to disable the vehicle, its SRS components and the high voltage electrical

system. To prevent current flow through the system, use the following procedure to

disable the vehicle.

3.1 Disabling the System –Smart Key System and “POWER”

START/STOP Button

3. Disable direct hazards / safety regulations 5

1. Confirm the status of the READY light on the

instrument panel. If the READY light is

illuminated, the vehicle is ON.

a) If the READY light is NOT illuminated, the

vehicle is off. Do not push the “POWER”

START/STOP button because the vehicle may

start (go into READY mode). EV START / STOP Button

Pressing

POWER button

Button

Position/LED Vehicle condition

One time ACC/ON Electrical accessories are operational.

Two times ON/ON The warning lights can be checked before

the vehicle is started.

Three times OFF Off

While depressing the brake pedal

Pressing

POWER button

Button

Position/LED Vehicle condition

One time -Ready to drive

Without depressing the brake pedal

b) To turn OFF the system, press the 'P' button, and press the POWER button.

2. Before disconnecting the 12V battery,

remove the Smart Key at least 2 meters away

from the vehicle to prevent accidental restart.

3. Disable direct hazards / safety regulations 6

SMART KEY

If necessary, lower the windows, unlock the doors and open the tail gate as required,

before disconnecting the 12V battery. Once the 12V battery is disconnected, power

controls will not operate.

NOTICE

3. Follow the procedure below to disconnect the 12V auxiliary battery negative (-)

terminal to prevent accidental restart.

B. Disconnect the 12V auxiliary battery

negative(-) terminal ①.

A. Open the tailgate and remove

the floorboard and luggage tray.

a) Remove the Junction block upper cover “A” in the PE (Power Electric) room,

located under the front hood.

4. Disconnect the High voltage cut-off switch.

3. Disable direct hazards / safety regulations 7

b) Disconnect the High voltage cut-off switch “B” as below.

①: Pull the cut-off switch → ②: Disconnected

B : Cut-off Switch

3. Disable direct hazards / safety regulations 8

•Before engaging in any emergency response procedures, ensure the vehicle is

disabled and wait 5 minutes to allow the capacitor in the high voltage system to

discharge to avoid electrocution.

•Exposed cables or wires may be visible inside or outside the vehicle. Never touch the

metal chassis wires, cables, connectors, or any electric components before disabling

the system, and/or shorted to the vehicle chassis.

Failure to follow these instructions will lead to serious bodily injury or death by

electrocution.

Electrocution Risk

Altri manuali per GV70

Indice

Altri manuali Genesis Automobile

Genesis

Genesis G80 2023 Manuale utente

Genesis

Genesis G70 2019 Manuale utente

Genesis

Genesis G90 2021 Manuale utente

Genesis

Genesis GV80 Scheda tecnica

Genesis

Genesis G90 2020 Manuale utente

Genesis

Genesis G90 2018 Manuale utente

Genesis

Genesis GV70 Manuale utente

Genesis

Genesis 2018 G80 Manuale utente

Genesis

Genesis G80 2020 Manuale utente

Genesis

Genesis 2018 G80 Manuale utente

Genesis

Genesis G70 Manuale utente

Genesis

Genesis G80 2020 Manuale utente

Genesis

Genesis GV80 2021 Manuale di installazione e funzionamento

Genesis

Genesis G80 2019 Manuale utente

Genesis

Genesis GV70 Manuale utente

Genesis

Genesis G90 2019 Manuale utente

Genesis

Genesis G90 2014 Manuale utente

Genesis

Genesis G70 2020 Manuale utente

Genesis

Genesis G90 2018 Manuale utente

Genesis

Genesis G70 Manuale utente

Genesis

Genesis COUPE BK 2010 Manuale utente

Genesis

Genesis G90 2017 Manuale utente

Genesis

Genesis GV60 2023 Manuale utente

Genesis

Genesis GV80 Manuale utente

Manuali Automobile popolari di altre marche

Toyota

Toyota 2000 Tundra Manuale utente

CITROËN

CITROËN DS4 DSign Manuale utente

Lexus

Lexus 2015 CT 200h Manuale utente

Cadillac

Cadillac CTS 2008 Manuale utente

Mercedes-Benz

Mercedes-Benz M-class ML 55 AMG Manuale utente

Porsche

Porsche Boxster S Manuale utente

GMC

GMC 2010 Savana 1500 Cargo Manuale utente

KIAM

KIAM SPORTAGE 2014 Manuale elenco delle parti

GMC

GMC 2013 Terrain Istruzioni per il montaggio

GMC

GMC T-Series 1999 Manuale utente

Mercury

Mercury 1998 Mystique Manuale utente

Mercury

Mercury 2007 Mariner Manuale utente

Mazda

Mazda 2007 Mazdaspeed 3 Guida

Mazda

Mazda 2014 CX-5 Manuale utente

GMC

GMC Chevrolet Express 2022 Manuale utente

GMC

GMC 1997 Jimmy Manuale utente

Chevrolet

Chevrolet 2012 Malibu Manuale utente

Cadillac

Cadillac 2010 Escalade Manuale utente