WARNING: POWERRATING:12V2A
Do notuse any other poweradapter
exceptthe one that accompanies this unit.
Use of otheradapter could resultin damage
to theunit. To prevent electronicsshock,
pleasedo not open the cover.
Designed in Sweden Made in China
Model: Pulse
P/N: 99618025
Version: 1.0
Date: 2018-05
S/N: XXXXXXXXXXXXXXXX
MAC: 00:22:07:XX:XX:XX
SSID: Genexis-xxxx
WiFi-Key:
**************
Manual pairing
Connect to your Pulse WiFi
Consult the information label at the bottom
of your Pulse. It shows the SSID of the WiFi
network (i.e. Genexis-xxxx). Connect to this
WiFi network with your computer.
Login to your Pulse settings page
Open a web browser on your computer and
login to the following page by replacing the
fi eld “xxxx” in http://Genexis-xxxx/ with your
SSID. Use the following login credentials:
Username: user
Password: user
Confi gure network settings
You will now be presented with the screen
above. From that screen, select your home
network and fi ll in the login credentials of
your home network.
After approximately 2 minutes the internet
LED turns yellow.
You have now connected your Pulse to your
home network. Your connection to the web
interface will be interrupted.
To continue using internet on your computer,
connect to your home network again.
5. Connect Pulse to your router
To get the best performance of your Pulse,
connect an Ethernet cable to the WAN port
of your Pulse and to one of the LAN ports of
your router.
For more information about your Pulse, have
a look at the Full Installation Guide
(https://genexis.eu/download-portal/#pulse)
or contact your service provider.
www.genexis.eu
Revision 1.5. - August 2018
Copyright © 2018 Genexis B.V. All rights reserved.
From now on the web interface for your
Pulse can only be reached by obtaining the
new IP address of your Pulse via the web
interface of your router.
Consult the advanced confi guration section
of the Full Installation Guide on how to
retrieve this IP address.
5
Information label
The information on this label is needed when con guring your Pulse.
On the label you can nd information on how to access the web
interface and what the login credentials are.
There are two labels included in the box. These are copies of the label
on the bottom of your Pulse.
It is important you keep one label somewhere safe as it contains
information essential to con gure your device. You can place your
spare label on page 20.
The second label may be retained by the device installer.
Information label
Quick Installation Guide
A Quick Installation Guide is included this is used to install your Pulse.
The Quick Installation Guide gives a step by step overview of the steps
you should take to install your Pulse.
Quick Installation Guide
